DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

HA13168H Просмотр технического описания (PDF) - Renesas Electronics

Номер в каталоге
Компоненты Описание
производитель
HA13168H
Renesas
Renesas Electronics Renesas
HA13168H Datasheet PDF : 11 Pages
1 2 3 4 5 6 7 8 9 10
HA13168H
External Parts Lineup
Operation with Different Value from the
Parts
Range of
Range of Recommended Value
No.
Function
Recommended More than the Range Less than the Range
C1
Bypass capacitor
Upper 100 µF
Unstable
(Chemical capacitor)
Lower ripple rejection
ratio
C2
To prevent oscillation
0.1 µF
Stability improve
Unstable
For stability of IC, this capacitor is
inserted near the power supply pin of
the IC. We recommend Polyester film
capacitor. *1
C3
To prevent oscillation *2
0.1 to 10000 µF
Unconfirmed
Unstable
C4
C5
To prevent oscillation *2
0.1 to 470 µF
Unconfirmed
Unstable
C7
C6
To prevent oscillation
10 to 470 µF
Unconfirmed
(ESR = 0.1 to 2 )
Unstable
D1, D2, Protection against mistake in joining. IF 1 A
The ability to protect The ability to protect
D3, D4 Terminal protection for short circuit to
terminal improve.
terminal lower.
+B when VCC terminal is open and
And there is some
for short circuit to GND when GND
possibility of
terminal is open.
destruction.
We recommend Schottky barrier
diodes.
Notes: 1. To improve stability, take notes of the below precautions.
(1) Use capacitor that is temperature independent.
(2) Use capacitor that is bias voltage independent.
(3) No secondary resonance (non-inductive) capacitor.
And, pay attention to the following points so that there can be an efficient bypass of high frequency noise.
(1) To eliminate PCB pattern inductance mount the capacitor as close as possible to the VCC and GND of
IC.
2. For using of the lower limit of recommended value, take notes of the below precautions.
(1) Use capacitor that is temperature independent.
(2) Use capacitor that is bias voltage independent.
(3) No secondary resonance (non-inductive) capacitor.
3. To eliminate PCB pattern inductance mount the capacitor as close as possible to the VCC and GND of IC
about C3, C4, C5, C6 and C7.
Rev.1.00 Jan 16, 2007 page 6 of 10

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]