ELJ-810-619 Просмотр технического описания (PDF) - EPIGAP optoelectronic GmbH
Номер в каталоге
Компоненты Описание
производитель
ELJ-810-619 Datasheet PDF : 5 Pages
| |||
Jumbo-LED
ELJ-810-619
15.11.2007
rev. 02
Remarks concerning optical radiation safety*
Up to a forward current of 350 mA, at continous operation, this product may be classified as LED
product Class 1M , according to standard IEC 60825-1:A2. Class 1M products are safe to eyes and
skin under normal conditions, including when users view the light beam directly. Class 1M products
produce either a highly divergent beam or a large diameter beam,so only a small part of the whole
light beam can enter the eye. However, such optical products can be harmful to the retina if the
beam is viewed using magnifying optical instruments. Therefore, users should not incorporate optics
that could concentrate the output into the eyes.
If intended to operate at higher continuous current (>350 mA), this product has to be (potentially)
classified as Class 3B LED. Class 3B LEDs may have sufficient power to cause an eye injury, both
from the direct beam and from reflections,so these products are therefore considered hazardous to
the eye. However, the extent and severity of any eye injury arising from an exposure to the light
beam of a Class 3B product will depend upon several factors including the radiant power entering
the eye and the duration of the exposure. Nontheless, adequate precautions should be taken to
avoid direct or indirect viewing into the beam..
INFRARED RADIATION
Do not view directly
with optical instruments
LED Class 1M
accord. DIN EN/IEC 60825-1:2001-11
IF < 350mA
INFRARED RADIATION
Do not expose to the beam
LED Class 3B
accord. DIN EN/IEC 60825-1:2001-11
IF > 350mA
*Note: Safety classification of an optical component mainly depends on the intended application and
the way the component is being used. Furthermore, all statements made to classification are based
on calculations and are only valid for this LED "as it is", and at continuous operation. Using pulsed
current or altering the light beam with additional optics may lead to different safety classifications.
Therefore these remarks should be taken as recommendation and guideline only.
We reserve the right to make changes to improve technical design and may do so without further notice.
Parameters can vary in different applications.All operating parameters must be validated for each customer application by the customer.
EPIGAP Optoelektronik GmbH, D-12555 Berlin, Köpenicker Str.325 b, Haus 201
Tel.: +49-30-6576 2543, Fax : +49-30-6576 2545
4 of 5
Share Link: 