DS1388 Просмотр технического описания (PDF) - Maxim Integrated

Номер в каталоге

Компоненты Описание

производитель

DS1388

I2C RTC/Supervisor with Trickle Charger and 512 Bytes EEPROM

Maxim Integrated 

I2C RTC/Supervisor with Trickle Charger

and 512 Bytes EEPROM

LOCAL GROUND PLANE (LAYER 2)

X1

CRYSTAL

X2

NOTE: AVOID ROUTING SIGNAL LINES

IN THE CROSSHATCHED AREA

(UPPER LEFT QUADRANT) OF

THE PACKAGE UNLESS THERE IS

GND

A GROUND PLANE BETWEEN THE

SIGNAL LINE AND THE DEVICE PACKAGE.

Figure 3. Layout Example

Clock Accuracy

The accuracy of the clock is dependent upon the accu-

racy of the crystal and the accuracy of the match

between the capacitive load of the oscillator circuit and

the capacitive load for which the crystal was trimmed.

Additional error is added by crystal frequency drift

caused by temperature shifts. External circuit noise

coupled into the oscillator circuit can result in the clock

running fast. Figure 3 shows a typical PC board layout

for isolation of the crystal and oscillator from noise.

Refer to Application Note 58: Crystal Considerations

with Dallas Real-Time Clocks for detailed information.

Address Map

Figure 4 shows the address map for the DS1388. The

memory map is divided into three blocks. The memory

block accessed is determined by the value of the block

address bits in the slave address byte. The timekeep-

ing registers reside in block 0h. During a multibyte

access of the timekeeping registers, when the internal

address pointer reaches 0Ch, it wraps around to loca-

tion 00h. On an I2C START or address pointer incre-

menting to location 00h, the current time is transferred

to a second set of registers. The time information is

read from these secondary registers, while the clock

may continue to run. This eliminates the need to reread

the registers in case the main registers update during a

read. The EEPROM is divided into two 256-byte blocks

located in blocks 1h and 2h. During a multibyte read of

the EEPROM registers, when the internal address point-

er reaches FFh, it wraps around to location 00h of the

block of EEPROM specified in the block address.

During a multibyte write of the EEPROM registers, when

the internal address pointer reaches the end of the cur-

rent 8-byte EEPROM page, it wraps around to the

beginning of the EEPROM page. See the Write

Operation section for details.

To avoid rollover issues when writing to the time and

date registers, all registers should be written before the

hundredths-of-seconds register reaches 99 (BCD).

Hundredths-of-Seconds

Generator

The hundredths-of-seconds generator circuit shown in

the Block Diagram is a state machine that divides the

incoming frequency (4096Hz) by 41 for 24 cycles and

40 for 1 cycle. This produces a 100Hz output that is

slightly off during the short term, and is exactly correct

every 250ms. The divide ratio is given by:

Ratio = [41 x 24 + 40 x 1] / 25 = 40.96

Thus, the long-term average frequency output is

exactly 100Hz.

10 ____________________________________________________________________

Share Link: