ATTINY13-12PI Просмотр технического описания (PDF) - Atmel Corporation

Номер в каталоге

Компоненты Описание

производитель

ATTINY13-12PI

8-bit Microcontroller with 1K Bytes In-System Programmable Flash

Atmel Corporation 

There are basically two types of interrupts. The first type is triggered by an event that

sets the Interrupt Flag. For these interrupts, the Program Counter is vectored to the

actual Interrupt Vector in order to execute the interrupt handling routine, and hardware

clears the corresponding Interrupt Flag. Interrupt Flags can also be cleared by writing a

logic one to the flag bit position(s) to be cleared. If an interrupt condition occurs while the

corresponding interrupt enable bit is cleared, the Interrupt Flag will be set and remem-

bered until the interrupt is enabled, or the flag is cleared by software. Similarly, if one or

more interrupt conditions occur while the Global Interrupt Enable bit is cleared, the cor-

responding Interrupt Flag(s) will be set and remembered until the Global Interrupt

Enable bit is set, and will then be executed by order of priority.

The second type of interrupts will trigger as long as the interrupt condition is present.

These interrupts do not necessarily have Interrupt Flags. If the interrupt condition disap-

pears before the interrupt is enabled, the interrupt will not be triggered.

When the AVR exits from an interrupt, it will always return to the main program and exe-

cute one more instruction before any pending interrupt is served.

Note that the Status Register is not automatically stored when entering an interrupt rou-

tine, nor restored when returning from an interrupt routine. This must be handled by

software.

When using the CLI instruction to disable interrupts, the interrupts will be immediately

disabled. No interrupt will be executed after the CLI instruction, even if it occurs simulta-

neously with the CLI instruction. The following example shows how this can be used to

avoid interrupts during the timed EEPROM write sequence..

Assembly Code Example

in r16, SREG ; store SREG value

cli ; disable interrupts during timed sequence

sbi EECR, EEMWE ; start EEPROM write

sbi EECR, EEWE

out SREG, r16 ; restore SREG value (I-bit)

C Code Example

char cSREG;

cSREG = SREG; /* store SREG value */

/* disable interrupts during timed sequence */

_CLI();

EECR |= (1<<EEMWE); /* start EEPROM write */

EECR |= (1<<EEWE);

SREG = cSREG; /* restore SREG value (I-bit) */

10 ATtiny13

2535B–AVR–01/04

Share Link: