ATMEGA32M1-MU Просмотр технического описания (PDF) - Atmel Corporation

Номер в каталоге

Компоненты Описание

производитель

ATMEGA32M1-MU

8-bit AVR® Microcontroller with 16/32/64K Bytes In-System Programmable Flash

Atmel Corporation 

ATmega16M1/32M1/64M1

The Idle mode stops the CPU while allowing the SRAM, Timer/Counters, SPI ports, CAN,

LIN/UART and interrupt system to continue functioning. The Power-down mode saves the regis-

ter contents but freezes the Oscillator, disabling all other chip functions until the next interrupt or

Hardware Reset. The ADC Noise Reduction mode stops the CPU and all I/O modules except

ADC, to minimize switching noise during ADC conversions. In Standby mode, the Crystal/Reso-

nator Oscillator is running while the rest of the device is sleeping. This allows very fast start-up

combined with low power consumption.

The device is manufactured using Atmel’s high-density nonvolatile memory technology. The On-

chip ISP Flash allows the program memory to be reprogrammed in-system through an SPI serial

interface, by a conventional nonvolatile memory programmer, or by an On-chip Boot program

running on the AVR core. The boot program can use any interface to download the application

program in the application Flash memory. Software in the Boot Flash section will continue to run

while the Application Flash section is updated, providing true Read-While-Write operation. By

combining an 8-bit RISC CPU with In-System Self-Programmable Flash on a monolithic chip,

the Atmel ATmega16M1/32M1/64M1 is a powerful microcontroller that provides a highly flexible

and cost effective solution to many embedded control applications.

The ATmega16M1/32M1/64M1 AVR is supported with a full suite of program and system devel-

opment tools including: C compilers, macro assemblers, program debugger/simulators, in-circuit

emulators, and evaluation kits.

2.2 Pin Descriptions

2.2.1 VCC

Digital supply voltage.

2.2.2 GND

Ground.

2.2.3

Port B (PB7..PB0)

Port B is an 8-bit bi-directional I/O port with internal pull-up resistors (selected for each bit). The

Port B output buffers have symmetrical drive characteristics with both high sink and source

capability. As inputs, Port B pins that are externally pulled low will source current if the pull-up

resistors are activated. The Port B pins are tri-stated when a reset condition becomes active,

even if the clock is not running.

Port B also serves the functions of various special features of the ATmega16M1/32M1/64M1 as

listed on page 72.

2.2.4

Port C (PC7..PC0)

Port C is an 8-bit bi-directional I/O port with internal pull-up resistors (selected for each bit). The

Port C output buffers have symmetrical drive characteristics with both high sink and source

capability. As inputs, Port C pins that are externally pulled low will source current if the pull-up

resistors are activated. The Port C pins are tri-stated when a reset condition becomes active,

even if the clock is not running.

Port C also serves the functions of special features of the ATmega16M1/32M1/64M1 as listed

on page 75.

7

8209C–AVR–05/10

Share Link: