ATF1504BE Просмотр технического описания (PDF) - Atmel Corporation

Номер в каталоге

Компоненты Описание

производитель

ATF1504BE

High-performance CPLD

Atmel Corporation 

3. Power Management

Unlike conventional CPLDs with sense amplifiers, the ATF1504BE is designed using low-power

full CMOS design techniques. This enables the ATF1504BE to achieve extremely low power

consumption over the full operating frequency spectrum.

The ATF1504BE also has an optional power-down mode. In this mode, current drops to below

100 µA. When the power-down option is selected, either PD1 or PD2 pins (or both) can be used

to power down the part. When enabled, the device goes into power-down when either PD1 or

PD2 is high. In the power-down mode, all internal logic signals are latched and held, as are any

enabled outputs.

All pin transitions are ignored until the PD pin is brought low. When the power-down feature is

enabled, the PD1 or PD2 pin cannot be used as a logic input or output. However, the pin’s mac-

rocell may still be used to generate buried foldback and cascade logic signals.

All power-down AC characteristic parameters are computed from external input or I/O pins.

4. Security Feature

A fuse is provided to prevent unauthorized copying of the ATF1504BE fuse patterns. Once

enabled, fuse reading or verification is inhibited. However, the 16-bit User Electronic Signature

remains accessible. To reset this feature, the entire memory array in the device must be erased.

5. Programming Methods

The ATF1504BE devices are In-System Programmable (ISP) or In-System Configurable (ISC)

devices utilizing the 4-pin JTAG protocol. This capability eliminates package handling normally

required for programming and facilitates rapid design iterations and field changes.

When using the ISP hardware or software to program the ATF1504BE devices, four I/O pins

must be reserved for the JTAG interface. However, the logic features that the macrocells have

associated with these I/O pins are still available to the design for buried logic functions.

To facilitate ISP programming by the Automated Test Equipment (ATE) vendors, Serial Vector

Format (SVF) files can be created by Atmel-provided software utilities. ATF1504BE devices can

also be programmed using standard third-party programmers. With a third-party programmer,

the JTAG ISP port can be disabled, thereby allowing four additional I/O pins to be used for logic.

The AT1504BE device supports several configuration modes which gives designers several

unique options for programming.

The different modes of programming are:

• ISC – In-System Configuration

• OTF – On-the-Fly Reconfiguration

• DRA – Direct Reconfiguration Access

10 ATF1504BE

3637B–PLD–1/08

Share Link: