AT28C64B Просмотр технического описания (PDF) - Atmel Corporation

Номер в каталоге

Компоненты Описание

производитель

AT28C64B

64K (8K x 8) CMOS E2PROM with Page Write and Software Data Protection

Atmel Corporation 

3. Block Diagram

AT28C64B

VCC

GND

OE

WE

CE

ADDRESS

INPUTS

OE, CE and WE

LOGIC

Y DECODER

X DECODER

DATA INPUTS/OUTPUTS

I/O0 - I/O7

DATA LATCH

INPUT/OUTPUT

BUFFERS

Y-GATING

CELL MATRIX

IDENTIFICATION

4. Device Operation

4.1 Read

The AT28C64B is accessed like a Static RAM. When CE and OE are low and WE is high, the

data stored at the memory location determined by the address pins is asserted on the outputs.

The outputs are put in the high-impedance state when either CE or OE is high. This dual line

control gives designers flexibility in preventing bus contention in their systems.

4.2 Byte Write

A low pulse on the WE or CE input with CE or WE low (respectively) and OE high initiates a write

cycle. The address is latched on the falling edge of CE or WE, whichever occurs last. The data is

latched by the first rising edge of CE or WE. Once a byte write has been started, it will automati-

cally time itself to completion. Once a programming operation has been initiated and for the

duration of tWC, a read operation will effectively be a polling operation.

4.3 Page Write

The page write operation of the AT28C64B allows 1 to 64 bytes of data to be written into the

device during a single internal programming period. A page write operation is initiated in the

same manner as a byte write; after the first byte is written, it can then be followed by 1 to 63

additional bytes. Each successive byte must be loaded within 150 µs (tBLC) of the previous byte.

If the tBLC limit is exceeded, the AT28C64B will cease accepting data and commence the internal

programming operation. All bytes during a page write operation must reside on the same page

as defined by the state of the A6 to A12 inputs. For each WE high to low transition during the

page write operation, A6 to A12 must be the same.

The A0 to A5 inputs specify which bytes within the page are to be written. The bytes may be

loaded in any order and may be altered within the same load period. Only bytes which are spec-

ified for writing will be written; unnecessary cycling of other bytes within the page does not occur.

3

0270L–PEEPR–2/09

Share Link: