AS1330(2010) Просмотр технического описания (PDF) - austriamicrosystems AG
Номер в каталоге
Компоненты Описание
производитель
AS1330 Datasheet PDF : 16 Pages
| |||
AS1330
Datasheet - Detailed Description
8 Detailed Description
The AS1330 can operate from a single-cell input voltage (VIN) below 1V, and features fixed frequency (4MHz) and cur-
rent mode PWM control for exceptional line- and load-regulation. With low RDS(ON) and gate charge internal NMOS
and PMOS switches, the device maintains high-efficiency from light to heavy loads.
Modern portable devices frequently spend extended time in low-power or standby modes, switching to high power-
drain only when certain functions are enabled. The AS1330 is ideal for portable devices since it maintain high-power
conversion efficiency over a wide output power range, thus increasing battery life in these types of devices.
In addition to high-efficiency at moderate and heavy loads, the AS1330 includes an automatic powersave mode that
improves efficiency of the power converter at light loads. The powersave mode is initiated if the output load current
falls below a factory programmed threshold.
Figure 19. AS1330 - Block Diagram
L1
1µH
AA Battery
6
VIN
C1
4.7µF
Start Up
OSC
PWM
Control
A A/B
B MUX
Sync Drive
Control
4MHz
Ramp
Generator
Slope
Compensator
Σ
+
PWM –
Comp
–
On
4
Off
EN
Shutdown
Control
Shutdown
RC
CP2
CC
Powersave
Powersave
Operation
Control
1 SW
–
VOUT
Good
+
1.65V
5
VOUT
0.25Ω 0.35Ω
Current
Sense
AS1330
3
–
gm Error
FB
Amp
+
0.8V
Ref
1
SENSE
Sense & POK
Logic
4
POK
2 GND
1.8V
Output
C2
4.7µF
Low-Voltage Start-Up
The AS1330 requires VIN of only 0.85V (typ) or higher to start up. The low-voltage start-up circuitry controls the internal
NMOS switch up to a maximum peak inductor current of 650mA (typ), with 1.5ms (approx.) off-time during start-up,
allowing the devices to start up into an output load.
With a VOUT > 1.65V, the start-up circuitry is disabled and normal fixed-frequency PWM operation is initiated. In this
mode, the AS1330 operates independent of VIN, allowing extended operating time as the battery can drop to several
tenths of a volt without affecting output regulation. The limiting factor for the application is the ability of the battery to
supply sufficient energy to the output.
www.austriamicrosystems.com/DC-DC_Step-Up/AS1330
Revision 1.04
8 - 16
Share Link: 