DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

AP358 Просмотр технического описания (PDF) - Diodes Incorporated.

Номер в каталоге
Компоненты Описание
производитель
AP358
Diodes
Diodes Incorporated. Diodes
AP358 Datasheet PDF : 15 Pages
1 2 3 4 5 6 7 8 9 10 Next Last
AP358
LOW POWER DUAL OPERATIONAL AMPLIFIERS
Electrical Characteristics ( TA = 25oC, V+ = +5.0V, unless otherwise stated ) (Note 7)
Symbol
VIO
IB
IIO
VICM
IS
AV
CMRR
PSRR
Parameter
Conditions
Input Offset Voltage
TA = 25oC, (Note 8)
Input Bias Current
IIN(+) or IIN(), TA = 25°C,
VCM = 0V, (Note 9)
Input Offset Current
IIN(+) - IIN(),VCM = 0V,
TA = 25°C
Input Common-Mode Voltage Range
V+ = 30V, (Note 10)
TA = 25°C
Supply Current
Over Full Temperature Range
RL = on V+ = 30V
All Op
Amps
V+ = 5V
V+ = 15V, TA = 25°C,
Large Signal Voltage Gain
RL > 2k,
(For VO = 1V to 11V)
Common-Mode Rejection Ratio
Power Supply Rejection Ratio
TA = 25°C, VCM = 0V to
V+ -1.5V
V+ = 5V to 30V,
TA = 25°C
f = 1KHz to 20 KHz,
Amplifier-to-Amplifier Coupling
TA = 25°C
(Input Referred),
(Note 11)
Min.
-
-
-
0
-
-
25
65
65
-
Typ.
2
45
Max. Unit
7 mV
250 nA
5
50 nA
- V+ -1.5 V
1
2
0.5 1.2 mA
100 - V/mV
85
- dB
100 - dB
-120 - dB
Note:
Note:
Note:
Note:
Note:
7. The AP358 temperature specifications are limited to 0°C < TA < +70°C.
8. VO 1.4V, RS = 0with V+ from 5V to 30V; and over the full input common-mode range (0V to V+ -1.5V) at 25°C.
9. The direction of the input current is out of the IC due to the PNP input stage. This current is essentially constant,
independent of the state of the output so no loading change exists on the input lines.
10. The input common-mode voltage of either input signal voltage should not be allowed to go negative by more than 0.3V (at
25°C). The upper end of the common-mode voltage range is V+ -1.5V (at 25°C), but either or both inputs can go to +32V
without damage, independent of the magnitude of V+.
11. Due to proximity of external components, insure that coupling is not originating via stray capacitance between these
external parts. This typically can be detected as this type of capacitance increases at higher frequencies.
AP358 Rev. 4
4 of 15
www.diodes.com
OCTOBER 2006
© Diodes Incorporated

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]