ADN2870
Parameter
SUPPLY
ICC 7
VCC (with respect to GND)8
Min Typ Max Unit Conditions/Comments
30
3.0 3.3 3.6
mA When IBIAS = IMOD = 0
V
1 Temperature range: −40°C to +85°C.
2 Measured into a 15 Ω load (22 Ω resistor in parallel with digital scope 50 Ω input) using a 11110000 pattern at 2.5 Gbps, shown in Figure 2.
3 Guaranteed by design and characterization. Not production tested.
4 When the voltage on DATAP is greater than the voltage on DATAN, the modulation current flows in the IMODP pin.
5 Guaranteed by design. Not production tested.
6 IBIAS/IBMON ratio stability is defined in SFF-8472 revision 9 over temperature and supply variation.
7 ICC minimum for power calculation (see the Power Consumption section).
8 All VCC pins should be shorted together.
VCC
VCC
ADN2870 R
22Ω
IMODP
L
C
BIAS TEE
80kHz → 27GHz
TO HIGH SPEED
DIGITAL
OSCILLOSCOPE
50Ω INPUT
Figure 2. High Speed Electrical Test Output Circuit
Rev. A | Page 4 of 20