ADL5505(Rev0) Просмотр технического описания (PDF) - Analog Devices
Номер в каталоге
Компоненты Описание
производитель
ADL5505 Datasheet PDF : 20 Pages
| |||
Parameter
RF INPUT (f = 6000 MHz)
Input Impedance
RMS Conversion
Dynamic Range1
±1 dB Error3
±2 dB Error3
Maximum Input Level
Minimum Input Level
Conversion Gain
Output Intercept4
Output Voltage, High Input Power
Output Voltage, Low Input Power
Temperature Sensitivity
VRMS OUTPUT
Output Offset
Maximum Output Voltage
Available Output Current
Pulse Response Time
Power-Up Response Time5
POWER SUPPLIES
Operating Range
Quiescent Current6
Test Conditions
Input RFIN to output VRMS
No termination
Min Typ
80||0.42
Continuous wave (CW) input, −40°C < TA < +85°C
±0.25 dB error3
±1 dB error3
VRMS = (gain × VIN) + intercept
PIN = 5 dBm, 400 mV rms
PIN = −15 dBm, 40 mV rms
PIN = 0 dBm
+25°C < TA < +85°C
−40°C < TA < +25°C
Pin VRMS
No signal at RFIN
VS = 3.0 V, RLOAD ≥ 10 kΩ
COUT = open, 10 dB step, 10% to 90% of settling level
COUT = open, 0 dBm at RFIN
23
33
11
−17
0.77
0.002
0.298
0.032
0.0103
0.0138
10
2.5
3
3
3
−40°C < TA < +85°C
No signal at RFIN
2.5
1.8
1 The available output swing and, therefore, the dynamic range are altered by the supply voltage; see Figure 8.
2 Error referred to delta from 25°C response; see Figure 13, Figure 14, Figure 15, Figure 19, Figure 20, and Figure 21.
3 Error referred to best-fit line at 25°C; see Figure 10, Figure 11, Figure 12, Figure 16, Figure 17, and Figure 18.
4 Calculated using linear regression.
5 The response time is measured from 10% to 90% of settling level; see Figure 30 and Figure 31.
6 Supply current is input level-dependent; see Figure 27.
ADL5505
Max Unit
Ω||pF
dB
dB
dBm
dBm
V/V rms
V
V
V
dB/°C
dB/°C
100 mV
V
mA
μs
μs
3.3 V
mA
Rev. 0 | Page 5 of 20
Share Link: 