TSM2415D Просмотр технического описания (PDF) - Traco Power

Номер в каталоге

Компоненты Описание

производитель

TSM2415D

1 Watt, input voltage range 5V, output voltage 12V (80mA), DC/DC converter

Traco Power 

DC/DC Converters

TSM Series

1 Watt

Input Specifications

Input current no load / full load

5 Vin models: 30 mA / 260 mA typ.

12 Vin models: 15 mA / 110 mA typ.

24 Vin models: 8 mA / 55 mA typ.

Surge voltage (1 sec. max.)

5 Vin models: 9 V max.

12 Vin models: 18 V max.

24 Vin models: 30 V max.

Reverse voltage protection 0.3 A max.

Reflected input ripple current can be reduced by ext. 1–2.2 µF polyester film

capacitor

Input filter internal capacitors

Output Specifications

Voltage set accuracy ±3 %

Voltage balance (dual output models) ±1 % max.

Regulation

– Input variation 1.2 % / 1 % change Vin

– Load variation 20 – 100 % 10 % max.

Ripple and noise (20 MHz Bandwidth) 120 mVpk-pk max.

Temperature coefficient ±0.02 %/°C

Short circuit protection limited 1 sec. max.

Capacitive load

single output models: 22 µF max.

dual output models: 10 µF max.

General Specifications

Temperature ranges

– Operating (see also enclosed derating curve) –40°C to +85°C (no derating)

– Storage –55°C to +125°C

Humidity (non condensing) 95 % rel H max.

Reliability, calculated MTBF (MIL-HDBK-217F, at+25°C, ground benign) >2’000’000 h

Isolation voltage (60 sec.) – Input/Output 1‘000 VDC

Isolation capacity

– Input/Output 40 pF typ.

Isolation resistance

– Input/Output >1‘000 Mohm

Switching frequency 100 kHz typ. (frequency modulation)

Frequency change over line and load ±30 %

Environmental compliance – Reach www.tracopower.com/products/reach-declaration.pdf

– RoHS RoHS directive 2011/65/EU

Physical Specifications

Casing material epoxy molding compound

(flammability to UL 94V-0 rated)

Package weight

single output models: 1.5 g (0.053 oz), 1.8 g (0.064 oz) for 24 Vin

dual output models: 1.8 g (0.064 oz), 2.2 g (0.078 oz) for 24 Vin

Moisture sensitivity level 3

Reflow soldering profile (IPC/JEDEC J-STD-020D) peak temp. 245°C (10 sec. max.)

217°C for 90 sec. max. Convection reflow

solder process is recommended

Packaging www.tracopower.com/overview/tsm

All specifications valid at nominal input voltage, full load and +25°C after warm-up time unless otherwise stated.

http://www.tracopower.com

Page 2 of 5

Share Link: