5962R9581801QXC Просмотр технического описания (PDF) - Intersil

Номер в каталоге

Компоненты Описание

производитель

5962R9581801QXC

Radiation Hardened 8-Bit Input/Output Port

Intersil 

HS-82C12RH

Functional Description

Data Latch

The data latch is comprised of eight “D” type flip-flops. The

output of each flip-flop will follow the corresponding data

input (DI0 - DI7) when the clock (C) is high. The clock input

is level sensitive and the data becomes latched when the

clock returns low.

An asynchronous reset (CLR) is used to clear the latched

data. Since the clock (C) overrides the reset (CLR), the data

must be in the latched state in order to clear the flip-flops. If

the data is not latched (i.e. clock is high) when CLR goes

low, then the Q outputs of the data latch will continue to

follow the data input, overriding the reset signal.

Output Buffer

Three-state buffers are used to provide output drive for the

data latch. A high level on the “output buffer enable” control

line enables the buffer outputs. When “output buffer enable”

is low the buffer outputs are forced to the high-impedance

state.

Device Select Logic

The inputs DS1 and DS2 are used for device selection.

When DS1 is low and DS2 is high, the device is selected.

The output buffers are enabled and the service request flip-

flop is asynchronously cleared when the device is selected.

Mode

the mode input (MD) is used to control the state of the output

buffer and to determine the source of the data latch clock

(C). When MD is high, the output buffers are enabled and

the source of the data latch clock (C) is the device select

logic (DS1 • DS2).

When MD is low, the state of the output buffer is controlled

by the device select logic (DS1 • DS2) and the source of the

data latch clock is the strobe (STB) input.

Strobe

The strobe input (STB) is used as the data latch clock (C)

when the mode input (MD) is low. The service request flip-

flop is synchronously set on the negative going edge of STB.

Service Request Flip-Flop

The service request flip-flop is to generate interrupts to

microcomputer systems. It is negative edge triggered and

asynchronously cleared (reset).

The output of the service request flip-flop is AND-gated with

the device select logic (DS1 • DS2). The output of the AND

gate is the active low interrupt (INT) signal.

4

Share Link: