DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

19-21-GHC-YR1S2 Просмотр технического описания (PDF) - EVERLIGHT

Номер в каталоге
Компоненты Описание
производитель
19-21-GHC-YR1S2
Everlight
EVERLIGHT Everlight
19-21-GHC-YR1S2 Datasheet PDF : 10 Pages
1 2 3 4 5 6 7 8 9 10
EVERLIGHT ELECTRONICS CO.,LTD.
19-21/GHC-YR1S2/3T
Precautions For Use
1. Over-current-proof
Customer must apply resistors for protection , otherwise slight voltage shift will cause big
current change ( Burn out will happen ).
2. Storage
2.1 Do not open moisture proof bag before the products are ready to use.
2.2 Before opening the package, the LEDs should be kept at 30or less and 90%RH or less.
2.3After opening the package, the LEDs should be kept at 30or less and 60%RH or less(Floor life).
However,it’s recommended that The LEDs should be used within 168 hours (7 days) after opening
the package.If unused LED remain, it should be stored in moisture proof packages.
2.4 If the moisture absorbent material (silica gel) has faded away or the LEDs have exceeded the
storage time, baking treatment should be performed using the following conditions.
Baking treatment : 60±5for 24 hours.
3. Soldering Condition
3.1 Pb-free solder temperature profile
3.2 Reflow soldering should not be done more than two times.
3.3 When soldering, do not put stress on the LEDs during heating.
3.4 After soldering, do not warp the circuit board.
4. Soldering Iron
Each terminal is to go to the tip of soldering iron temperature less than 350for 3 seconds
within once in less than the soldering iron capacity 25W. Leave two seconds and more intervals, and do
soldering of each terminal. Be careful because the damage of the product is often started at the time of
the hand solder.
Everlight Electronics Co., Ltd.
Device No:SZDSE-191-G14
http://www.everlight.com
Prepared date: 20-Aug-2005
Rev. 1
Page: 9 of 10
Prepared by: Meng Yali

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]