Philips Semiconductors
Full bridge driver IC
Preliminary specification
UBA2030T
SYMBOL
PARAMETER
CONDITIONS
MIN. TYP.
Shut-down; note 2
VIH
HIGH-level input voltage
shut-down active; -∆----V∆----St---D-- > 5 V/ms 4.5
−
VIL
LOW-level input voltage
shut-down not active;
-∆----V∆----St---D-- > 5 V/ms
0
−
Ii(SD)
input current
0
−
Notes
1. The current into pin HV is internally limited to 15 mA at Tj = 25 °C and to 10 mA at Tj = 150 °C.
2. VDD = 15 V.
3. The bridge frequency can be calculated using Equation (1).
4. The ‘dead time’ is adjusted using an external resistor; see Equation (2).
5. This function is disabled when using an external oscillator.
6. IIH < 2.1 mA when the condition is VBE − VBER = 5 V at Tj = 150 °C.
MAX.
VDD
0.5
50
UNIT
V
V
µA
Design equations
BRIDGE COMMUTATION FREQUENCY
The internal ÷2 circuit requires the frequency of the
internal or external oscillator to be twice the bridge
frequency. When the internal oscillator is used, the bridge
frequency can be adjusted using an external resistor and
capacitor:
fbridge = 2----.--8----×-----R-----o-1-s---c---×-----C-----o--s--c-
(1)
Where:
Rosc(min) = 200 kΩ
Rosc(max) = 2 MΩ (with low leakage current).
DEAD TIME
RDT = 270 × tdead – 70
(2)
The ‘dead time’ (tdead) can be adjusted using an external
resistor (RDT) connected between DTC and SGND:
Units are kΩ for RDT and µs for tdead.
Where:
RDT(min) = 50 kΩ
RDT(max) = 1 MΩ.
1999 Aug 10
11