MAX682 Просмотр технического описания (PDF) - Maxim Integrated

Номер в каталоге

Компоненты Описание

производитель

MAX682

3.3V-Input to Regulated 5V-Output Charge Pumps

Maxim Integrated 

3.3V-Input to Regulated 5V-Output

Charge Pumps

Typical Operating Characteristics (continued)

(Circuit of Figure 5, VIN = 3.3V, component values from Tables 2 and 3, TA = +25°C, unless otherwise noted.)

SHUTDOWN TIMING

MAX682 TOC18

A

LINE-TRANSIENT RESPONSE

MAX682 TOC20

A

LOAD-TRANSIENT RESPONSE

MAX682 TOC19

A

B

B

B

100µs/div

A: OUTPUT VOLTAGE: SKIP = HIGH, RL = 5V / IMAX, 2V/div

B: SHDN VOLTAGE: 1V/div

2ms/div

A: INPUT VOLTAGE: VIN = 3.1V TO 3.6V, 500mV/div

B: OUTPUT VOLTAGE: SKIP = HIGH, ISHDN = 22µA,

ILOAD = 250mA, 50mV/div, MAX682

2ms/div

A: LOAD CURRENT: ILOAD = 5mA TO 250mA, 500mA/div

B: OUTPUT VOLTAGE: SKIP = HIGH, ISHDN = 22µA,

100mV/div, MAX682

Pin Description

PIN NAME

FUNCTION

When SKIP = low, the regulator operates in low-quiescent-current skip mode. When SKIP = high, the

1

SKIP

regulator operates in constant-frequency mode, minimizing output ripple and noise. SKIP must be tied

high for input voltages above 3.6V.

Shutdown Input. Drive SHDN through an external resistor. When SHDN = low, the device turns off. When

2

SHDN current is sourced into SHDN through REXT, the device activates, and the SHDN pin input current sets the

oscillator’s switching frequency. REXT (kΩ) = 45000 (V IN - 0.69V) / fOSC (kHz).

3

IN

Input Supply Pin. Can range from 2.7V to 5.5V for SKIP = high, and 2.7V to 3.6V for SKIP = low. Bypass to

PGND with a suitable value capacitor (see Capacitor Selection section).

4

GND Ground Pin. Connect to PGND through a short trace.

5

PGND Power Ground Pin

6

CXN Negative Terminal of the Charge-Pump Transfer Capacitor

7

CXP

Positive Terminal of the Charge-Pump Transfer Capacitor

8

OUT Fixed 5V Power Output. Bypass to PGND with output filter capacitor.

_______________________________________________________________________________________ 5

Share Link: