MAX533 Просмотр технического описания (PDF) - Maxim Integrated

Номер в каталоге

Компоненты Описание

производитель

MAX533

2.7V, Low-Power, 8-Bit Quad DAC with Rail-to-Rail Output Buffers

Maxim Integrated 

2.7V, Low-Power, 8-Bit Quad DAC

with Rail-to-Rail Output Buffers

For this command, the data bits are “Don't Cares.” As

an example, three MAX533s are daisy chained (A, B,

and C), and devices A and C need to be updated. The

36-bit-wide command would consist of one 12-bit word

for device C, followed by an NOP instruction for device

B and a third 12-bit word with data for device A. At CS’s

rising edge, device B will not change state.

Set DOUT Phase—SCLK Rising (Mode 1)

A1 A0 C1 C0 D7 D6 D5 D4 D3 D2 D1 D0

1 11 0 xx x xx x xx

(LDAC = x)

Mode 1 resets the serial-output DOUT to transition at

SCLK’s rising edge. Once this command is issued,

DOUT’s phase is latched and will not change except on

power-up or if the specific command to set the phase

to falling edge is issued.

This command also loads all DAC registers with the con-

tents of their respective input registers, and is identical to

the “LDAC” command.

Set DOUT Phase—SCLK Falling (Mode 0, Default)

A1 A0 C1 C0 D7 D6 D5 D4 D3 D2 D1 D0

1 0 1 0 xxx xx x xx

(LDAC = x)

This command resets DOUT to transition at SCLK’s falling

edge. The same command also updates all DAC registers

with the contents of their respective input registers, identical

to the “LDAC” command.

LDAC Operation (Hardware)

LDAC is typically used in 4-wire interfaces (Figure 7). This

command is level sensitive, and it allows asynchronous

hardware control of the DAC outputs. With LDAC low, the

DAC registers are transparent, and any time an input regis-

ter is updated, the DAC output immediately follows.

Clear DACs with CLR

Strobing the CLR pin low causes an asynchronous

clear of input and DAC registers and sets all DAC out-

puts to zero. Similar to the LDAC pin, CLR can be

invoked at any time, typically when the device is not

selected (CS = H). When the DAC data is all zeros, this

function is equivalent to the “Update all DACs from Shift

Registers” command.

Serial Data Output

DOUT is the internal shift register’s output. DOUT can

be programmed to clock out data on SCLK’s falling

edge (mode 0) or rising edge (mode 1). In mode 0, out-

put data lags input data by 12.5 clock cycles, maintain-

ing compatibility with Microwire and SPI. In mode 1,

output data lags input data by 12 clock cycles. On

power-up, DOUT defaults to mode 0 timing. DOUT

never three-states; it always actively drives either high

or low and remains unchanged when CS is high.

SCLK

MAX533 DIN

CS

SK

SO

MICROWIRE

PORT

I/0

Figure 4. Connections for Microwire

MAX533 DIN

SCLK

CS

MOSI

SPI/QSPI

PORT

SCK

I/0

CPOL = 0, CPHA = 0

Figure 5. Connections for SPI/QSPI

______________________________________________________________________________________ 11

Share Link: