DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

DS1990A Просмотр технического описания (PDF) - Maxim Integrated

Номер в каталоге
Компоненты Описание
производитель
DS1990A
MaximIC
Maxim Integrated MaximIC
DS1990A Datasheet PDF : 10 Pages
1 2 3 4 5 6 7 8 9 10
Serial Number iButton
Hardware Configuration
The 1-Wire bus has only a single line by definition; it is
important that each device on the bus be able to drive
it at the appropriate time. To facilitate this, each device
attached to the 1-Wire bus must have open-drain or
three-state outputs. The 1-Wire port of the DS1990A is
open drain with an internal circuit equivalent to that
shown in Figure 4. A multidrop bus consists of a 1-Wire
bus with multiple slaves attached. At standard speed,
the 1-Wire bus has a maximum data rate of 16.3kbps.
The value of the pullup resistor primarily depends on
the network size and load conditions. For most applica-
tions, the optimal value of the pullup resistor is approxi-
mately 2.2kΩ. The idle state for the 1-Wire bus is high.
If for any reason a transaction needs to be suspended,
the bus must be left in the idle state if the transaction is
to resume. If this does not occur and the bus is left low
for more than 120µs, one or more devices on the bus
may be reset.
Transaction Sequence
The protocol for accessing the DS1990A through the
1-Wire port is as follows:
• Initialization
• ROM Function Command
Initialization
All transactions on the 1-Wire bus begin with an initial-
ization sequence. The initialization sequence consists
of a reset pulse transmitted by the bus master followed
by presence pulse(s) transmitted by the slave(s). The
presence pulse lets the bus master know that the
DS1990A is on the bus and is ready to operate. For
more details, see the 1-Wire Signaling section.
SIMPLE BUS MASTER
Rx
Tx
OPEN-DRAIN
PORT PIN
VPUP
RPUP
Rx = RECEIVE
Tx = TRANSMIT
DS1990A 1-Wire PORT
DATA
Rx
Tx
100Ω MOSFET
DS2480B BUS MASTER
HOST CPU
VDD
VPP
POL
1-W
SERIAL IN
SERIAL
RXD
N.C.
PORT
SERIAL OUT
TXD
GND
Figure 4. Hardware Configuration
DS2480B
+5V
TO 1-Wire DATA
_______________________________________________________________________________________ 5

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]