DS1990 Просмотр технического описания (PDF) - Dallas Semiconductor -> Maxim Integrated

Номер в каталоге

Компоненты Описание

производитель

DS1990

Serial Number iButton™

Dallas Semiconductor -> Maxim Integrated 

DS1990A

1-WIRE SIGNALING

The DS1990A requires strict protocols to ensure data integrity. The protocol consists of four types of

signaling on one line: Reset sequence with Reset Pulse and Presence Pulse, write 0, write 1 and read data.

All these signals except presence pulse are initiated by the bus master.

The initialization sequence required to begin any communication with the DS1990A is shown in Figure 5.

A Reset Pulse followed by a Presence Pulse indicates the DS1990A is ready to send or receive data given

the correct ROM command.

The bus master transmits (TX ) a reset pulse ( a low signal for a minimum of 480 µs). The bus master then

releases the line and goes into receive mode (RX ). The 1-Wire bus is pulled to a high state via the

5 kΩ pullup resistor. After detecting the rising edge on the data contact, the DS1990A waits (tPDH , 15-60

µs) and then transmits the presence pulse (tPDL , 60-240 µs).

READ/WRITE TIME SLOTS

The definitions of write and read time slots are illustrated in Figure 6. All time slots are initiated by the

master driving the data line low. The falling edge of the data line synchronizes the DS1990A to the

master by triggering a delay circuit in the DS1990A. During write time slots, the delay circuit determines

when the DS1990A will sample the data line. For a read data time slot, if a “0” is to be transmitted, the

delay circuit determines how long the DS1990A will hold the data line low overriding the 1 generated by

the master. If the data bit is a “1”, the iButton will leave the read data time slot unchanged.

INITIALIZATION PROCEDURE “RESET AND PRESENCE PULSES” Figure 5

RESISTOR

MASTER

DS1990A

480 µs ≤ tRSTL < ∞ *

480 µs ≤ tRSTH < ∞ (includes recovery time)

15 µs ≤ tPDH < 60 µs

60 µs ≤ tPDL < 240 µs

∗ In order not to mask interrupt signaling by other devices on the 1-Wire bus, tRSTL + tR should always

be less than 960 µs.

6 of 10

Share Link: