25F1024AN Просмотр технического описания (PDF) - Unspecified

Номер в каталоге

Компоненты Описание

производитель

25F1024AN

1Mbit High Speed SPI Serial Flash Memory

Unspecified 

Features

• Serial Peripheral Interface (SPI) Compatible

• Supports SPI Modes 0 (0,0) and 3 (1,1)

– Datasheet Describes Mode 0 Operation

• 33 MHz Clock Rate

• Byte Mode and 256-byte Page Mode for Program Operations

• Sector Architecture:

– Four Sectors with 32K Bytes Each (1M)

– 128 Pages per Sector

• Product Identification Mode

• Low-voltage Operation

– 2.7 (VCC = 2.7V to 3.6V)

• Sector Write Protection

• Write Protect (WP) Pin and Write Disable Instructions for

both Hardware and Software Data Protection

• Self-timed Program Cycle (20 µs/Byte Typical)

• Self-timed Sector Erase Cycle (1 second/Sector Typical)

• Single Cycle Reprogramming (Erase and Program) for Status Register

• High Reliability

– Endurance: 10,000 Write Cycles Typical

– Data Retention: 20 Years

• Lead-free/Halogen-free Devices

• 8-lead JEDEC SOIC and 8-lead SAP Packages

1Mbit High

Speed SPI

Serial Flash

Memory

1M (131,072 x 8)

AT25F1024A

Description

The AT25F1024A provides 1,048,576 bits of serial reprogrammable Flash memory

organized as 131,072 words of 8 bits each. The device is optimized for use in many

industrial and commercial applications where low-power and low-voltage operation

are essential. The AT25F1024A is available in a space-saving 8-lead JEDEC SOIC

and 8-lead SAP packages.

The AT25F1024A is enabled through the Chip Select pin (CS) and accessed via a 3-

wire interface consisting of Serial Data Input (SI), Serial Data Output (SO), and Serial

Clock (SCK). All write cycles are completely self-timed.

Block Write protection for top 1/4, top 1/2 or the entire memory array is enabled by

programming the status register. Separate write enable and write disable instructions

are provided for additional data protection. Hardware data protection is provided via

the WP pin to protect against inadvertent write attempts to the status register. The

HOLD pin may be used to suspend any serial communication without resetting the

serial sequence.

Rev. 3346G–SFLSH–7/07

Share Link: