DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

LA4625(2000) Просмотр технического описания (PDF) - SANYO -> Panasonic

Номер в каталоге
Компоненты Описание
производитель
LA4625
(Rev.:2000)
SANYO
SANYO -> Panasonic SANYO
LA4625 Datasheet PDF : 8 Pages
1 2 3 4 5 6 7 8
LA4625
3. Impulse noise improvements
• While the LA4625 achieves a low level of impulse noise, if even further reductions in impulse noise at power on/off
(and when switching into or out of standby mode) a 0.47 µF capacitor may be inserted between pin 7 and the PRE
GND pin (pin 3). (Pin 7 is the output amplifier bias pin. Since the ability to withstand shorting the output pins to
VCC or ground is reduced for supply voltages over 16 V if the pin 7 capacitance is large, we recommend a value of
0.47 µF or lower for this capacitor.)
4. Protection circuits
• Due to the system structure of the protection circuit for shorts to VCC or ground, if there is a DC resistance between
the amplifier output pins and ground, the protection circuit may operate when power is first applied and the
amplifier may fail to turn on. The basic design approach we recommend is not to adopt any designs in which there is
a DC resistance between the amplifier outputs and ground.
• The LA4625 includes a built-in thermal protection circuit to prevent the IC from being damaged or destroyed if
abnormally high temperatures occur. This thermal protection circuit gradually reduces the output if the IC junction
temperature (Tj) reaches the range 170 to 180°C due to inadequate heat sinking or other problem. If the temperature
falls, the amplifier will restart automatically.
• The LA4625 also includes other protection circuits. Use of these circuits also requires care during end product
design and testing.
5. Other notes
• The LA4625 is a BTL power amplifier. When testing this device, the ground systems for the test equipment
connected to IC inputs, and that for the test equipment connected to IC outputs, must be isolated. Do not use a
common ground.
Printed Circuit Pattern
(copper foil side)
GND
C5
14
VCC
GND
R2 C6
R3 C7
--OUT1
+OUT1
GND
R4 C8
R5 C9
--OUT2
+OUT2
1
LA4625
C1
IN1
C2
STB
R1
C3
IN2
C4
C10
ILA00349
No. 6631-5/8

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]