MTL003 Просмотр технического описания (PDF) - Myson Century Inc

Номер в каталоге

Компоненты Описание

производитель

MTL003

SXGA Flat Panel Controller

Myson Century Inc 

MYSON

TECHNOLOGY

MTL003

(Rev. 0.95)

¨ V/H SYNC Frequency Counter

MTL003 measures VSYNC/HSYNC frequency counted in the proper clock and using the following formulae:

fvsync = fosc / Nvsync 51/256

fhsync = fosc / Nhsync 58

Where

fvsync

fhsync

fosc

Nvsync

Nhsync

: VSYNC frequency

: HSYNC frequency

: oscillator clock with 14.31818 MHz

: counted number of VSYNC

: counted number of HSYNC

¨ V/H SYNC Presence Check

This function checks the input VSYNC, where Vpre flag is set when VSYNC is over 40Hz or cleared when

VSYNC is under 10Hz and the input is HSYNC, where Hpre flag is set when HSYNC is over 10KHz or

cleared when HSYNC is under 10Hz.

¨ V/H Polarity Detect

This function detects the input VSYNC/HSYNC high and low pulse duty cycle. If the high pulse duration is

longer than that of low pulse, the negative polarity is asserted; otherwise, positive polarity is asserted.

¨ Composite SYNC separation/insertion

MTL003 continuously monitors the input HSYNC. If the input VSYNC can be extracted from it, a CVpre flag is

set. MTL003 can insert HSYNC pulse during Composite VSYNC’s active time and the insertion frequency

can adapt to original HSYNC’s.

3.1.7 Auto Tune

Auto Tune function consists of Auto Position that automatically centering the screen and Auto Calibration

which contains Phase Calibration, Histogram, Min/Max Value, and Pixel Grab described as below. With this

auto adjustment support it is possible to measure the correct phase, frequency, gain, and offset of ADC. The

horizontal and vertical back porches of input image and the horizontal and vertical active regions can also be

measured. Firmware can adjust input image registers automatically by reading Auto Tune’s registers in single

or burst mode.

¨ Auto Position

MTL003 provides Horizontal/Vertical back porch and active region values. Users can use these values to set

input sample registers to aid in centering the screen automatically.

¨ Phase Calibration

MTL003 provides Auto Calibration registers to measure the quality of current ADC’s phase and frequency.

The biggest Auto Calibration registers value means the right value of ADC’s phase and frequency. MTL003

has two kinds of algorithms to calculate Auto Calibration’s value. One is the traditional Difference method, the

other is MYSON’s proprietary method; the latter one is recommended for a better performance.

¨ Histogram

Histogram means the total number of input pixels below/above one threshold value, for individual R/G/B

colors. This advanced function helps the firmware to analyze ADC performance. Usually the firmware can

use this information to measure ADC’s noise margin, and adjust its offset and gain, or even aid in the mode

detection.

¨ Min/Max Value

Min/Max value means minimum or maximum pixel value within the specified input active image region for

each RGB channel. This information is usually used to adjust ADC’s offset and gain.

¨ Pixel Grab

Pixel Grab means users can grab a single input pixel at any one point. The position of the point can be

programmed by users. This is another traditional method to measure ADC’s phase and frequency.

Revision 0.95

-8-

2000/06/14

Share Link: