SPT9405SCL Просмотр технического описания (PDF) - Signal Processing Technologies
Номер в каталоге
Компоненты Описание
производитель
SPT9405SCL Datasheet PDF : 4 Pages
| |||
ABSOLUTE MAXIMUM RATINGS (Beyond which damage may occur)(1) 25 °C
Supply Voltages
VCC ....................................................................... +6.0 V
Maximum Power Dissipation
PD .................................................................................... 150 mW
Thermal Impedance (TA=+25 °C and above)
ΘCA ............................................................................ 1.2 mW/°C
Temperature
Operating Temperature ................................. 0 to +70 °C
Storage Temperature ................................ -55 to +150 °C
Note: 1. Operation at any Absolute Maximum Rating is not implied. See Electrical Specifications for proper nominal
applied conditions in typical applications.
ELECTRICAL SPECIFICATIONS
TA = +25 °C, VCC = +5.0 V, VIN = 1.0 VP-P video signal, RL = 150 Ω, unless otherwise specified.
PARAMETERS
Power Supply
Supply Current (ICC)
VCC Voltage
Power Dissipation
Standby Current
Standby Power Dissipation
Digital Input
Digital Input (Low)
Digital Input (High)
Bias Voltage
Clamp Voltage
Dynamic Performance
Voltage Gain
Differential Gain
Differential Phase
Frequency Response
TEST
CONDITIONS
No Input
Pin 1 Grounded
Pin 1 Grounded
Standby Pin 1
Standby Pin 1
Pin 4
fIN = 1 MHz
Ramp Input 3.58 MHz
Ramp Input 3.58 MHz
fIN = 1 to 5 MHz
TEST
LEVEL
I
IV
I
I
I
I
I
I
I
I
I
V
MIN
4.5
0.0
1.8
1.05
5.4
-3.0
-3.0
SPT9405
TYP
7.5
5.0
37.5
24.0
120
0.1
2.0
1.25
5.9
-0.6
-0.2
-0.5
MAX UNITS
10 mA
5.5 V
50 mW
50 µA
250 µW
0.3 V
VCC V
1.45 V
6.4 dB
+3.0 %
+3.0 Degrees
dB
TEST LEVEL CODES
All electrical characteristics are subject to the following
conditions:
All parameters having min/max specifications are guar-
anteed. The Test Level column indicates the specific
device testing actually performed during production and
Quality Assurance inspection. Any blank section in the
data column indicates that the specification is not tested
at the specified condition.
TEST LEVEL
I
II
III
IV
V
VI
TEST PROCEDURE
100% production tested at the specified temperature.
100% production tested at TA = +25 °C, and sample tested
at the specified temperatures.
QA sample tested only at the specified temperatures.
Parameter is guaranteed (but not tested) by design and
characterization data.
Parameter is a typical value for information purposes only.
100% production tested at TA = +25 °C. Parameter is
guaranteed over specified temperature range.
SPT
2
SPT9405
8/25/98
Share Link: 