NJ88C50 Просмотр технического описания (PDF) - Mitel Networks
Номер в каталоге
Компоненты Описание
производитель
NJ88C50 Datasheet PDF : 15 Pages
| |||
NJ88C50
ARCHITECTURE
Fig.2 shows a simplified block diagram of the NJ88C50, a
more detailed description of each block and its function is
given later in this datasheet.
The synthesiser consists of the following blocks
- 35MHz reference frequency input buffer
- 35MHz programmable reference divider
- 125MHz Auxiliary synthesiser input buffer
- 125MHz Auxiliary synthesiser programmable divider
- Auxiliary synthesiser phase detector with current source
outputs
- 30MHz main synthesiser input buffer (differential inputs)
- 30MHz main synthesiser programmable divider and control
logic
- Main synthesiser Fractional-N interpolation system
- Main synthesiser phase detector with dual current source
outputs
PIN DESCRIPTION
Pin Name
1
AVDD
2
FIM
3
FIMB
4
DATA
5
CKIN
6
STROBE
7
RI
8
FIA
9
RSA
10 PDA
11 PDI
12 GND
13 PDP
14 VDD
15 RSM
16 RSC
17 SCREEN
18 MOD1
19 MOD2
20 AGND
Function
Analog supply pin (nominally 5V).
Main synthesiser balanced input buffer, may be used with single ended prescaler output if Fimb
is biased.
Main synthesiser balanced input buffer, may be used with balanced prescaler output, or biased
for single ended operation.
Serial input for programming data.
Serial clock input for programming bus.
Program enable pin, active low.
Master reference frequency input, should be a.c coupled from an accurate source.
Auxiliary synthesiser frequency input, should be a.c coupled.
Current setting resistor connection defining auxiliary phase detector output current.
Tristate current output from auxiliary phase detector.
Tristate current output from the main synthesiser's phase detector giving integral control.
Digital ground supply pin.
Tristate current output from the main synthesiser's phase detector giving proportional control.
Digital supply pin (nominally 5V).
Current setting resistor connection defining main synthesiser's phase detector output currents.
Current setting resistor connection defining the compensation current for fractional-N ripple
elimination in the main synthesiser's current source outputs.
To be connected to ground to provide isolation of the modulus control pins from RF interference.
Modulus control pin (see truth table).
Modulus control pin (see truth table).
Analog ground supply pin.
It is recommended that power supply pins are well decoupled to minimise power rail born interference.
2
Share Link: 