SY89430V(2000) Просмотр технического описания (PDF) - Micrel
Номер в каталоге
Компоненты Описание
производитель
SY89430V Datasheet PDF : 9 Pages
| |||
Micrel
ClockWorks™
SY89430V
PIN DESCRIPTIONS
INPUTS
OUTPUTS
XTAL1, XTAL2
FOUT, FOUT
These pins form an oscillator when connected to an external These differential positive-referenced ECL signals (PECL)
crystal. The crystal is series resonant.
are the output of the synthesizer.
S_LOAD
This TTL pin loads the configuration latches with the contents
of the shift registers. The latches will be transparent when this
signal is HIGH; thus, the register data must be stable on the
HIGH-to-LOW transition of S_LOAD for proper operation.
TEST
The function of this TTL output is determined by the serial
configuration bits T[2:0].
POWER
S_DATA
This TTL pin is the input to the serial configuration shift
registers.
S_CLOCK
This TTL pin clocks the serial configuration shift registers. On
the rising edge of this signal, data from S_DATA is sampled.
P_LOAD
This TTL pin loads the configuration latches with the contents
of the parallel inputs. The latches will be transparent when this
signal is LOW; thus, the parallel data must be stable on the
LOW-to-HIGH transition of P_LOAD for proper operation.
M[8:0]
These TTL pins are used to configure the PLL loop divider.
They are sampled on the LOW-to-HIGH transition of P_LOAD.
M[8] is the MSB, M[0] is the LSB. The binary count on the M
pins equates to the divide-by value for the PLL.
N[1:0]
These TTL pins are used to configure the output divider
modulus. They are sampled on the LOW-to-HIGH transition
of P_LOAD.
N[1:0]
00
Output Division
2
VCC1
This is the positive supply for the chip and is normally
connected to +3.3V or +5.0V.
VCC_OUT
This is the positive reference for the PECL outputs, FOUT and
FOUT. It is constrained to be less than or equal to VCC1.
VCC_QUIET
This is the positive supply for the PLL and should be as noise-
free as possible for low-jitter operation.
GND
These pins are the negative supply for the chip and are
normally all connected to ground.
OTHER
LOOP_FILTER
This is an analog I/O pin that provides the loop filter for the
PLL.
LOOP_REF
This is an analog I/O pin that provides a reference voltage for
the PLL.
01
4
10
8
11
1
ABSOLUTE MAXIMUM RATINGS(1)
Symbol
Parameter
Value
Unit
VCC
Power Supply Voltage
–0.5 to +7.0
V
VI
Input Voltage
–0.5 to +7.0
V
IOUT
Output Source
Continuous
50
mA
Surge
100
Tstore
TA
Storage Temperature
Operating Temperature
–65 to +150
°C
–0 to +75
°C
NOTE:
1. Permanent device damage may occur if ABSOLUTE MAXIMUM RATINGS are exceeded. This is a stress rating only and functional operation is not implied at
conditions other than those detailed in the operational sections of this data sheet. Exposure to ABSOLUTE MAXIMUM RATlNG conditions for extended periods may
affect device reliability.
3
Share Link: 