Smart High-Side Power Switch
BTS711L1
Timing diagrams
Timing diagrams are shown for chip 1 (channel 1/2). For chip 2 (channel 3/4) the diagrams
are valid too. The channels 1 and 2, respectively 3 and 4, are symmetric and consequently
the diagrams are valid for each channel as well as for permuted channels
Figure 1a: Vbb turn on:
,1
Figure 2b: Switching an inductive load
,1
,1
9 EE
9
287
67
W G67
9
287
9
287
67 RSHQ GUDLQ
Figure 2a: Switching a lamp:
,1
,/
, /2/
W
W
*) if the time constant of load is too large, open-load-status may
occur
Figure 3a: Turn on into short circuit:
shut down by overtemperature, restart by cooling
,1 RWKHU FKDQQHO QRUPDO RSHUDWLRQ
67
9
287
,
/
, /6&S
, /6&U
,
/
W
The initial peak current should be limited by the lamp and not by
the initial short circuit current IL(SCp) = 7.5 A typ. of the device.
W RI I6&
67
W
Heating up of the chip may require several milliseconds, depending
on external conditions (toff(SC) vs. Tj,start see page 11)
Data Sheet
13
Rev 1.2, 2010-03-16