CXA1372BQ Просмотр технического описания (PDF) - Sony Semiconductor
Номер в каталоге
Компоненты Описание
производитель
CXA1372BQ Datasheet PDF : 32 Pages
| |||
CXA1372BQ/BS
DIRC (Pin 20) and 1 Track Jump
Normally, an acceleration pulse is applied for a 1-track jump. Then a deceleration pulse is given for a specified
time observing the tracking error from the moment it passes point 0, and tracking servo is turned ON again.
For the 100-track jump to be explained in the next item, as long as the number of tracks is about 100 there is
no problem. However a 1-track jump must be performed here, which requires the above complicated
procedure. For the 1-track jump in CD players, both the acceleration and deceleration take about 300 to
400µs. When software is used to execute this operation, it turns out as shown in the flow chart of Fig. 9.
Actually, it takes some time to transfer data.
Pulse waveform
Deceleration
Acceleration
Tracking error
Fig. 8. Pulse waveform and tracking error of 1-track jump
$2C transfer latch
$28 transfer only
TR: REV
SL: OFF
Execute
TR: FWD
SL: OFF
$2C transfer latch
TR: REV
SL: OFF
Execute
TZC ↓ ?
NO
YES
Latch
Execute
TZC ↓ ?
NO
YES
DIRC = L
TR: FWD
SL: OFF
Timer (0.3ms)
Timer (0.3ms)
$25 transfer latch
TR: ON
SL: ON
Execute
DIRC = H
TR: ON
SL: ON
Fig. 9. 1-track jump not using DIRC (Pin 20)
Fig. 10. 1-track jump with DIRC (Pin 20)
The DIRC (Direct Control) pin was provided in this IC to facilitate the 1-track jump operation. Conduct the
following process to perform 1-track jump using DIRC (normal High).
(a) Acceleration pulse is output. ($2C for REV or $28 for FWD).
(b) With TZC ↓ (or TZC ↑), set DIRC to Low. (SENS Pin 27 outputs "TZC"). As the jump pulse polarity is
inverted, deceleration is applied.
(c) Set DIRC to High after a specific time.
Both the tracking servo and sled servo are switched ON automatically.
As a result, the track jump turns out as shown in the flow chart of Fig. 10 and the two serial data transfers
can be omitted.
– 22 –
Share Link: 