SL2009
Characteristics
IF amplifier
Input impedance
Noise Figure
Variation in NF with gain
adjust
Output referred IP3
Gain
Maximum
Minimum
Output impedance
Output limiting
AGC2 leakage current
Notes:
pin
min
typ
max units
Conditions
1,2
2
kΩ Differential, see figure (8)
3
pF
4
6
dB Tamb=27˚C, referred to
source impedance of 2 kΩ
conversion gain set at 40 dB
-1 dB/dB
5,7
5
dBV With gains of 24dB and
above, see note (2)
4
dBV With gains from 20dB to
24dB, see note (2)
38
5,7
Voltage conversion gain from
2 kΩ differential source to 1
kΩ // 15 pF single-ended
load, see figure (7)
dB Vagc2=1.0V
20
dB Vagc2=4.25V
AGC monotonic from Vee to
V cc
25
Ω Single-ended, see figure (9)
5,7
1.8
Vp-p
Single-ended into to 1 kΩ //
15 pF load. 3rd Harmonic of
wanted output signal better
than 10dBC.
4
-110
110
µA
Table 2 - Electrical Characteristics (continued)
(1) Two output tones at 104 dBµV within operating range
(2) Two output tones at 108 dBµV within operating range
(3) When controlling external AGC the current load on AGCOUT should be minimised
(4) For maximum performance, capacitive load should be resonated with appropriate inductance at chosen IF
frequency.
Absolute Maximum Ratings
All voltages are referred to Vee at 0V, and VccIF=VccSAW
8