MT90221 Просмотр технического описания (PDF) - Mitel Networks

Номер в каталоге

Компоненты Описание

производитель

MT90221

Quad IMA/UNI PHY Device

Mitel Networks 

MT90221

Byte

Description

Control Source

1-5

ICP Cell Header

Content of Header is under S/W control. The HEC is calculated by H/W.

6

OAM label

S/W control

7

Cell ID, Link ID

The Link ID is programmed through other registers and inserted by H/W

8

IMA Frame Sequence Hardware Control

9

ICP Cell Offset

H/W Control. (Programmed by S/W through other registers)

10

Link Stuff Indication

H/W Control

11

Status Change Indic. H/W Control

12

IMA ID

S/W Control

13 Group Status and Control S/W Control except for value of M

14

Sync. Info.

H/W Control (Programmed by S/W through other registers)

15

Test Control

S/W Control

16

TX Test Pattern

S/W Control

17

RX Test Pattern

S/W Control

18-49 Link Status and Control S/W Control

50

Unused

S/W Control

51

End-to-End Channel S/W Control

52-53

CRC Error Control

H/W Calculation

Table 2 - ICP Cell Description

location is transmitted in all ICP cells, Stuff

Cells and Filler cells sent on all the links that

are part of the corresponding TX IMA group

• Byte 7 - the TX Link ID register is used to set

the Link Logical ID and the cell type is

determined by the internal controller on a per

link basis

• Byte 8 - the frame sequence number is

controlled by an internal counter

• Byte 9 - the TX ICP Cell Offset register is used

to set the value. This value is inserted on a per

link basis

• Byte 10 - the link Stuff indication is inserted

automatically and the advance indication option

is programmed by the TX IMA Control register

on a per link basis

• Byte 11 - the SCCI is controlled by internal

circuitry. The SCCI is incremented by one for

each transfer of the TX ICP cell from the buffer

area to the TX Cell RAM.

• Byte 13 - the value of M is programmed through

the TX Group Control Mode register

• Byte 14 - the TX Group Control Mode register

is used to set the Transmit Timing Information

and define the reference link

• Bytes 52 and 53 - the calculated CRC-10 Error

Control bits are inserted automatically

Software controls all remaining bytes of the ICP

cells. It also maintains and updates all bytes that are

not directly controlled by the MT90221. A dedicated

address is reserved for each ICP cell byte for each of

the four IMA Groups. This permits direct access to

any of the bytes stored in each of the four ICP Cell

registers. Refer to Table 2, ICP Cell Description, for

details on the ICP cell byte contents.

To avoid updating or corruption problems, the

internal copy of the ICP Cell cannot be directly

accessed. ICP cells are prepared in a buffer area

(RAM inside the MT90221) and transfer commands

are issued to copy the content of the ICP cell into the

internal Cell RAM area and to start using this new

ICP cell. The MT90221 uses a flag (status bit) to

indicate that this transfer is underway. Changes

should not be made to the content of the ICP cell in

the buffer area until the transfer to the internal

memory is complete. The status bit is cleared during

the transfer and returns to ’1’ on completion of the

transfer. IMA Groups are controlled independently.

When access to the ICP cell of one group is

prohibited, the other ICP cell buffer areas can still be

updated. The TX ICP Cell Handler and TX ICP

Interrupt Enable registers are used to initiate a

transfer and enable an optional interrupt to indicate

when the process is complete.

13

Share Link: