DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

MP230 Просмотр технического описания (PDF) - Apex Microtechnology

Номер в каталоге
Компоненты Описание
производитель
MP230
Apex
Apex Microtechnology Apex
MP230 Datasheet PDF : 5 Pages
1 2 3 4 5
MP230
OPERATING
CONSIDERATIONS
any parasitic resistances RP, formed by socket and solder joints
as well as internal amplifi er losses.The current limiting resistor
may not be placed anywhere in the output circuit except where
shown in Figure 2. The value of the current limit resistor can
be calculated as follows: RLIM = .65/ILIMIT
BOOST OPERATION
With the boost feature the small signal stages of the amplifier
are operated at a higher supply voltages than the amplifier’s
high current output stage. +VB (pin 1) and -VB (pin 38) are
connected to the small signal stages. An additional 10V on the
+VB and -VB pin is sufficient to allow the small signal stages
to drive the output stage into the triode region and improve
the output voltage swing for extra efficient operation when
required. When the boost feature is not needed +VS and
-VS are connected to +VB and -VB respectively. +VB and -VB
must not be operated at supply voltages less than +VS and
-VS respectively.
SHUTDOWN
The output stage is turned off by applying a 5V level to HSD
(pin 8) relative to LSD (pin 7). This is a non-latching circuit. As
long as HSD remains high relative to LSD the output stage will
be turned off. LSD will normally be tied to signal ground but
LSD may float from -VB to +VB - 10V. Shutdown can be used
to lower quiescent current for standby operation or as part of
a load protection circuit.
BIAS CLASS OPTION
Normally pin 5 (Iq) is left open. But when pin 5 is connected
to pin 6 (Cc1) the quiescent current in the output stage is dis-
abled. This results in lower quiescent power, but also class
C operation of the output stage and the resulting crossover
distortion. In many applications, such as driving motors, the
distortion may be unimportant and lower standby power dis-
sipation is an advantage.
APTEhiXs dMatIaCRshOeeTtEhCaHs NbeOeLnOcaGreYfuCllOy RchPeOckRedATanIOd Nis belTieEvLeEdPtoHbOeNreElia(b5le2,0h)ow6e9ve0r,-n8o6r0es0ponsFibAilXity(5is2a0ss)um8e8d8fo-r3p3o2ss9ible OinRacDcuErRacSie(s5o2r o0m)is6si9o0ns-.8A6ll0sp1ecifiEcMatiAonILs aprerosudbljietc@t toapcheaxnmgeiwcritohtoeuct hno.ctiocem.
MP230U REV F DECEMBER 2004 © 2004 Apex Microtechnology Corp.
5

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]