MFRC523 Просмотр технического описания (PDF) - NXP Semiconductors.

Номер в каталоге

Компоненты Описание

производитель

MFRC523

Contactless Reader IC

NXP Semiconductors. 

NXP Semiconductors

MFRC523

Contactless reader IC

This command automatically terminates when the data stream ends. This is indicated

either by the end of frame pattern or by the length byte depending on the selected frame

type and speed.

Remark: If the RxModeReg register’s RxMultiple bit is set to logic 1, the Receive

command will not automatically terminate. It must be terminated by starting another

command in the CommandReg register.

10.3.1.8 Transceive

This command continuously repeats the transmission of data from the FIFO buffer and the

reception of data from the RF field. The first action is transmit and after transmission the

command is changed to receive a data stream.

Each transmit process must be started by setting the BitFramingReg register’s StartSend

bit to logic 1. This command must be cleared by writing any command to the

CommandReg register.

Remark: If the RxModeReg register’s RxMultiple bit is set to logic 1, the Transceive

command never leaves the receive state because this state cannot be cancelled

automatically.

10.3.1.9 MFAuthent

This command manages MIFARE authentication to enable a secure communication to

any MIFARE Mini, MIFARE 1K and MIFARE 4K card. The following data is written to the

FIFO buffer before the command can be activated:

• Authentication command code (60h, 61h)

• Block address

• Sector key byte 0

• Sector key byte 1

• Sector key byte 2

• Sector key byte 3

• Sector key byte 4

• Sector key byte 5

• Card serial number byte 0

• Card serial number byte 1

• Card serial number byte 2

• Card serial number byte 3

In total 12 bytes are written to the FIFO.

Remark: When the MFAuthent command is active all access to the FIFO buffer is

blocked. However, if there is access to the FIFO buffer, the ErrorReg register’s WrErr bit is

set.

This command automatically terminates when the MIFARE card is authenticated and the

Status2Reg register’s MFCrypto1On bit is set to logic 1.

MFRC523_33

Product data sheet

PUBLIC

All information provided in this document is subject to legal disclaimers.

Rev. 3.3 — 5 March 2010

115233

© NXP B.V. 2010. All rights reserved.

71 of 98

Share Link: