MCP2122-EP Просмотр технического описания (PDF) - Microchip Technology
Номер в каталоге
Компоненты Описание
производитель
MCP2122-EP Datasheet PDF : 38 Pages
| |||
4.3 Timing Diagrams and Specifications
FIGURE 4-3:
EXTERNAL CLOCK TIMING
Q4
16XCLK
Q1
Q2
1
Q3
3
3
MCP2122
Q4
Q1
4
4
TABLE 4-3: EXTERNAL CLOCK TIMING REQUIREMENTS
AC Characteristics
Standard Operating Conditions (unless otherwise specified)
Operating Temperature: –40°C ≤ TA ≤ +125°C (Extended)
Operating Voltage VDD range is described in
Section 4.1 “DC Characteristics”
Param.
No.
Sym
Characteristic
Min
Typ(1) Max Units
Conditions
1
TXCLK External 16XCLK Period (2, 3) 542.5
—
—
ns
1A FXCLK External 16XCLK
Frequency (2, 3)
1C
EXCLK Clock Error (4, 5)
DC
— 1.8432 MHz
—
—
±2
% Note 5
3 TXCLKL, Clock in (16XCLK)
TXCLKH Low or High Time
50
—
—
ns
4 TXCLKR, Clock in (16XCLK)
TXCLKF Rise or Fall Time (5)
—
—
7.5
ns Note 5
Note 1: Data in the Typical (“Typ”) column is at 5V, +25°C, unless otherwise stated. These parameters are for
design guidance only and are not tested.
2: All specified values are based on characterization data for that particular oscillator type under standard
operating conditions with the device executing code. Exceeding these specified limits may result in an
unstable oscillator operation and/or higher than expected current consumption.
When an external clock input is used, the “max” cycle time limit is “DC” (no clock) for all devices.
3: A duty cycle of no more than 60/40 (High-Time/Low-Time or Low-Time/High-Time) is recommended for
external clock inputs.
4: This is the clock error from the desired clock frequency. The total system clock error includes the error from
the transmitter and the error of receiver (from the desired clock frequency). If the transmitter is 2% fast from
the target frequency, and the receiver is 2% slow from the target frequency, the total error is 4%.
5: These parameters (shaded) are characterized but are not tested. These values should be used for design
guidance only.
© 2007 Microchip Technology Inc.
Preliminary
DS21894C-page 21
Share Link: 