MB95110M Series
• Mode Pin (MOD)
Connect the MOD pin directly to VCC or VSS pins.
To prevent the device unintentionally entering test mode due to noise, lay out the printed circuit board so as to
minimize the distance from the MOD pin to VCC or VSS pins and to provide a low-impedance connection.
Use a ceramic capacitor or a capacitor with equivalent frequency characteristics. A bypass capacitor of VCC pin
must have a capacitance value higher than CS. For connection of smoothing capacitor CS, refer to the diagram
below.
• C pin connection diagram
C
CS
• NC Pins
Any pins marked “NC” (not connected) must be left open.
• Analog Power Supply
Always set the same potential to AVCC and VCC. When VCC > AVCC, the current may flow through the AN00 to
AN07 pins.
15