MAX5024 Просмотр технического описания (PDF) - Maxim Integrated
Номер в каталоге
Компоненты Описание
производитель
MAX5024
Maxim Integrated
MAX5024 Datasheet PDF : 13 Pages
| |||
65V, Low-Quiescent-Current, High-Voltage Linear
Regulators with µP Reset and Watchdog Timer
EN and HOLD. Figure 3 shows the timing diagram for the
enable and hold functions. Connecting HOLD to OUT or
floating HOLD allows the EN input to act as a standard
ON/OFF switch for the regulator output.
Thermal Protection
When the junction temperature exceeds TJ = +150°C, an
internal thermal sensor signals the shutdown logic that
turns off the pass transistor and allows the IC to cool.
The thermal sensor turns the pass transistor on again
after the IC’s junction temperature cools by 20°C, result-
ing in a cycled output during continuous thermal-over-
VIN
load conditions. Thermal protection protects the
MAX5023/MAX5024 in the event of fault conditions. For
continuous operation, do not exceed the absolute maxi-
mum junction temperature rating of TJ = +150°C.
Applications Information
Output Voltage Selection (MAX5024 only)
The MAX5024 features Dual Mode™ operation: it oper-
ates in either a preset voltage mode or an adjustable
mode. In preset voltage mode, internal trimmed feed-
back resistors set the MAX5024’s internal linear
regulator to +3.3V or +5V (see the Selector Guide).
VEN
VEN, ON
VEN, OFF
VHOLD
VHOLD, REL
VHOLD, HOLD
VOUT
VOUT (NOM)
1)
2)
VRESET
200ms
5)
>10µs
>10µs
4)
6)
7)
VTH
8)
9)
3)
0.2V
1) ENABLE ACTIVE
2) HOLD INACTIVE, PULLED UP BY VOUT
3) POWER-ON RESET
4) HOLD ACTIVE, CLAMPED TO GND BY EXTERNAL µP
5) ENABLE INACTIVE, CLAMPED BY INT, PULLDOWN RESISTOR
Figure 3. Enable and Hold Behavior
Dual Mode is a trademark of Maxim Integrated Products, Inc.
6) PULSE WIDTH SMALLER THAN 10µs
7) HOLD INACTIVE, RELEASED BY µP
8) REGULATOR OUTPUT SHUTDOWN
9) OUTPUT-LOW RESET
_______________________________________________________________________________________ 9
Share Link: