MAX16904 Просмотр технического описания (PDF) - Maxim Integrated
Номер в каталоге
Компоненты Описание
производитель
MAX16904 Datasheet PDF : 14 Pages
| |||
2.1MHz, High-Voltage,
600mA Mini-Buck Converter
2) Solder the exposed pad to a large copper plane
area under the device. To effectively use this copper
area as heat exchanger between the PCB and ambi-
ent, expose the copper area on the top and bottom
side. Add a few small vias or one large via on the
copper pad for efficient heat transfer. Connect the
exposed pad to PGND ideally at the return terminal
of the output capacitor.
3) Isolate the power components and high current
paths from sensitive analog circuitry.
4) Keep the high current paths short, especially at the
ground terminals. The practice is essential for stable
jitter-free operation.
5) Connect the PGND and GND together preferably at
the return terminal of the output capacitor. Do not
connect them anywhere else.
6) Keep the power traces and load connections short.
This practice is essential for high efficiency. Use
thick copper PCB to enhance full load efficiency and
power dissipation capability.
7) Route high-speed switching nodes away from sensi-
tive analog areas. Use internal PCB layers as PGND
to act as EMI shields to keep radiated noise away
from the device and analog bypass capacitor.
ESD Protection
The device’s ESD tolerance is rated for Human Body
Model and Machine Model. The Human Body Model
discharge components are CS = 100pF and RD = 1.5kΩ
(Figure 1). The Machine Model discharge components
are CS = 200pF and RD = 0Ω (Figure 2).
RD
1MΩ
1.5kΩ
HIGH-
VOLTAGE
DC
SOURCE
CHARGE-CURRENT-
LIMIT RESISTOR
CS
100pF
DISCHARGE
RESISTANCE
STORAGE
CAPACITOR
DEVICE
UNDER
TEST
RD
0Ω
HIGH-
VOLTAGE
DC
SOURCE
CHARGE-CURRENT-
LIMIT RESISTOR
CS
200pF
DISCHARGE
RESISTANCE
STORAGE
CAPACITOR
DEVICE
UNDER
TEST
Figure 1. Human Body ESD Test Circuit
Figure 2. Machine Model ESD Test Circuit
12
Share Link: 