LPC2101 Просмотр технического описания (PDF) - Philips Electronics

Номер в каталоге

Компоненты Описание

производитель

LPC2101

Single-chip 16-bit/32-bit microcontrollers; 8 kB/16 kB/32 kB flash with ISP/IAP, fast ports and 10-bit ADC

Philips Electronics 

Philips Semiconductors

LPC2101/2102/2103

Single-chip 16-bit/32-bit microcontrollers

– Set HIGH on match.

– Toggle on match.

– Do nothing on match.

6.14 General purpose 16-bit timers/external event counters

The Timer/Counter is designed to count cycles of the peripheral clock (PCLK) or an

externally supplied clock and optionally generate interrupts or perform other actions at

specified timer values, based on four match registers. It also includes three capture inputs

to trap the timer value when an input signal transitions, optionally generating an interrupt.

Multiple pins can be selected to perform a single capture or match function, providing an

application with ‘or’ and ‘and’, as well as ‘broadcast’ functions among them.

The LPC2101/2102/2103 can count external events on one of the capture inputs if the

minimum external pulse is equal or longer than a period of the PCLK. In this configuration,

unused capture lines can be selected as regular timer capture inputs or used as external

interrupts.

6.14.1 Features

• Two 16-bit timer/counters with a programmable 16-bit prescaler.

• External event counter or timer operation.

• Three 16-bit capture channels that can take a snapshot of the timer value when an

input signal transitions. A capture event may also optionally generate an interrupt.

• Four 16-bit match registers that allow:

– Continuous operation with optional interrupt generation on match.

– Stop timer on match with optional interrupt generation.

– Reset timer on match with optional interrupt generation.

• Four external outputs per timer/counter corresponding to match registers, with the

following capabilities:

– Set LOW on match.

– Set HIGH on match.

– Toggle on match.

– Do nothing on match.

6.15 Watchdog timer

The purpose of the watchdog is to reset the microcontroller within a reasonable amount of

time if it enters an erroneous state. When enabled, the watchdog will generate a system

reset if the user program fails to ‘feed’ (or reload) the watchdog within a predetermined

amount of time.

6.15.1 Features

• Internally resets chip if not periodically reloaded.

• Debug mode.

• Enabled by software but requires a hardware reset or a watchdog reset/interrupt to be

disabled.

LPC2101_02_03_1

Preliminary data sheet

Rev. 01 — 18 January 2006

© Koninklijke Philips Electronics N.V. 2006. All rights reserved.

16 of 32

Share Link: