LICAL-TRC-MT Просмотр технического описания (PDF) - Unspecified

Номер в каталоге

Компоненты Описание

производитель

LICAL-TRC-MT

MT Series Transcoder Module Data Guide

Unspecified 

MODE_IND

This line will switch when a valid transmission is received, when Learn

Mode or Create Mode is entered, and when the memory is cleared. This

allows for the connection of a LED to indicate to the user that these events

have taken place.

SEL_BAUD

This line is used to select the baud rate of the serial data stream. If the line

is high, the baud rate will be 28,800bps, if it is low, the baud rate will be

9,600bps. The baud rate must be set before power up. The transcoder will

not recognize any change in the baud rate setting after it is on.

LATCH

If this line is low, then the data outputs will be momentary (active for as

long as a valid signal is received). If this line is high, the outputs will be

latched (when a signal is received to make a particular data line high, it will

remain high until another transmission is received instructing it to go low)

by default, but individual status lines can be set as latched or momentary

through the SIE.

–7–

Share Link: