RMWL05001 Просмотр технического описания (PDF) - Raytheon Company
Номер в каталоге
Компоненты Описание
производитель
RMWL05001 Datasheet PDF : 6 Pages
| |||
RMWL05001
5 GHz Low Noise Amplifier MMIC
Application
Information
PRODUCT INFORMATION
CAUTION: THIS IS AN ESD SENSITIVE DEVICE.
Chip carrier material should be selected to have GaAs compatible thermal coefficient of expansion and high thermal
conductivity such as copper molybdenum or copper tungsten. The chip carrier should be machined, finished flat,
plated with gold over nickel and should be capable of withstanding 325°C for 15 minutes.
Die attachment should utilize Gold/Tin (80/20) eutectic alloy solder and should avoid hydrogen environment for
PHEMT devices. Note that the backside of the chip is gold plated and is used as RF and DC ground.
These GaAs devices should be handled with care and stored in dry nitrogen environment to prevent contamination
of bonding surfaces. These are ESD sensitive devices and should be handled with appropriate precaution including
the use of wrist grounding straps. All die attach and wire/ribbon bond equipment must be well grounded to prevent
static discharges through the device.
Recommended wire bonding uses 3 mils wide and 0.5 mil thick gold ribbon with lengths as short as practical
allowing for appropriate stress relief. The RF input and output bonds should be typically 0.012” long corresponding
to a typically 2 mil between the chip and the substrate material.
Figure 1
Functional Block
Diagram
Drain Supply
Vd
MMIC Chip
RF IN
RF OUT
Figure 2
Schematic of
Application Circuit
Amplifier is self-biased.
No gate supply is
required.
Ground
(Back of chip)
Drain Supply
Vd=+4 V
10,000pF
L 100pF
L
MMIC Chip
RF IN
L = Bond Wire Inductance
RF OUT
www.raytheon.com/micro
Ground
(Back of chip)
Characteristic performance data and specifications are subject to change without notice.
Revised March 2, 2001
Page 2
Raytheon RF Components
362 Lowell Street
Andover, MA 01810
Share Link: 