DS1220Y Просмотр технического описания (PDF) - Dallas Semiconductor -> Maxim Integrated

Номер в каталоге

Компоненты Описание

производитель

DS1220Y

16k Nonvolatile SRAM

Dallas Semiconductor -> Maxim Integrated 

NOT RECOMMENDED FOR NEW DESIGNS

READ MODE

DS1220Y

The DS1220Y executes a read cycle whenever WE (Write Enable) is inactive (high) and CE (Chip

Enable) and OE (Output Enable) are active (low). The unique address specified by the 11 address inputs

(A0-A10) defines which of the 2048 bytes of data is to be accessed. Valid data will be available to the

eight data output drivers within tACC (Access Time) after the last address input signal is stable, providing

that CE and OE access times are also satisfied. If CE and OE access times are not satisfied, then data

access must be measured from the later-occurring signal and the limiting parameter is either tCO for CE or

tOE for OE rather than address access.

WRITE MODE

The DS1220Y executes a write cycle whenever the WE and CE signals are active (low) after address

inputs are stable. The later-occurring falling edge of CE or WE will determine the start of the write

cycle. The write cycle is terminated by the earlier rising edge of CE or WE . All address inputs must be

kept valid throughout the write cycle. WE must return to the high state for a minimum recovery time

(tWR) before another cycle can be initiated. The OE control signal should be kept inactive (high) during

write cycles to avoid bus contention. However, if the output drivers are enabled ( CE and OE active)

then WE will disable the outputs in tODW from its falling edge.

DATA RETENTION MODE

The DS1220Y provides full-functional capability for VCC greater than 4.5 volts and write protects at 4.25

nominal. Data is maintained in the absence of VCC without any additional support circuitry. The

DS1220Y constantly monitors VCC. Should the supply voltage decay, the NV SRAM automatically write

protects itself, all inputs become “don’t care,” and all outputs become high-impedance. As VCC falls

below approximately 3.0 volts, a power switching circuit connects the lithium energy source to RAM to

retain data. During power-up, when VCC rises above approximately 3.0 volts, the power switching circuit

connects external VCC to RAM and disconnects the lithium energy source. Normal RAM operation can

resume after VCC exceeds 4.5 volts.

2 of 9

Share Link: