ATTINY25-20PI Просмотр технического описания (PDF) - Atmel Corporation

Номер в каталоге

Компоненты Описание

производитель

ATTINY25-20PI

8-bit Microcontroller with 2/4/8K Bytes In-System Programmable Flash

Atmel Corporation 

7. Errata

The revision letter in this section refers to the revision of the ATtiny25/45/85 device.

7.1 ATtiny25/45/85 Rev. A

• Too high power down power consumption

• DebugWIRE looses communication when single stepping into interrupts

• PLL not locking

1. Too high power down power consumption

Three situations will lead to a too high power down power consumption. These are:

– An external clock is selected by fuses, but the IO PORT is still enabled as an output.

– The EEPROM is read before entering power down.

– VCC is 4.5 volts or higher.

Problem fix / Workaround

– When using external clock, avoid setting the clock pin as Output.

– Do not read the EEPROM if power down power consumption is important.

– Use VCC lower than 4.5 Volts.

2. DebugWIRE looses communication when single stepping into interrupts

When receiving an interrupt during single stepping, debugwire will loose

communication.

Problem fix / Workaround

– When singlestepping disable interrupts.

– When debugging interrupts, use breakpoints within the interrupt routine, and run into

the interrupt.

3. PLL not locking

When running at frequencies below 6.0 MHz, the PLL will not lock

Problem fix / Workaround

– When using the PLL, run at 6.0 MHz or higher.

14 ATtiny25/45/85

2586AS–AVR–02/05

Share Link: