ATMEGA162 Просмотр технического описания (PDF) - Atmel Corporation

Номер в каталоге

Компоненты Описание

производитель

ATMEGA162

8-bit AVR Microcontroller with 16K Bytes In-System Programmable Flash

Atmel Corporation 

ATmega162/V

Pin Descriptions

VCC

GND

Port A (PA7..PA0)

Port B (PB7..PB0)

Port C (PC7..PC0)

• The timed sequence for changing the Watchdog Time-out period is disabled. See “Timed

Sequences for Changing the Configuration of the Watchdog Timer” on page 56 for details.

• The double buffering of the USART Receive Registers is disabled. See “AVR USART vs.

AVR UART – Compatibility” on page 168 for details.

• Pin change interrupts are not supported (Control Registers are located in Extended I/O).

• One 16 bits Timer/Counter (Timer/Counter1) only. Timer/Counter3 is not accessible.

Note that the shared UBRRHI Register in ATmega161 is split into two separate registers in

ATmega162, UBRR0H and UBRR1H. The location of these registers will not be affected by the

ATmega161 compatibility fuse.

Digital supply voltage

Ground

Port A is an 8-bit bi-directional I/O port with internal pull-up resistors (selected for each bit). The

Port A output buffers have symmetrical drive characteristics with both high sink and source

capability. When pins PA0 to PA7 are used as inputs and are externally pulled low, they will

source current if the internal pull-up resistors are activated. The Port A pins are tri-stated when a

reset condition becomes active, even if the clock is not running.

Port A also serves the functions of various special features of the ATmega162 as listed on page

72.

Port B is an 8-bit bi-directional I/O port with internal pull-up resistors (selected for each bit). The

Port B output buffers have symmetrical drive characteristics with both high sink and source

capability. As inputs, Port B pins that are externally pulled low will source current if the pull-up

resistors are activated. The Port B pins are tri-stated when a reset condition becomes active,

even if the clock is not running.

Port B also serves the functions of various special features of the ATmega162 as listed on page

72.

Port C is an 8-bit bi-directional I/O port with internal pull-up resistors (selected for each bit). The

Port C output buffers have symmetrical drive characteristics with both high sink and source

capability. As inputs, Port C pins that are externally pulled low will source current if the pull-up

resistors are activated. The Port C pins are tri-stated when a reset condition becomes active,

even if the clock is not running. If the JTAG interface is enabled, the pull-up resistors on pins

PC7(TDI), PC5(TMS) and PC4(TCK) will be activated even if a Reset occurs.

Port C also serves the functions of the JTAG interface and other special features of the

ATmega162 as listed on page 75.

5

2513K–AVR–07/09

Share Link: