AT24CS02-WWU11M Просмотр технического описания (PDF) - Atmel Corporation

Номер в каталоге

Компоненты Описание

производитель

AT24CS02-WWU11M

I2C-Compatible (2-wire) Serial EEPROM with a Unique, Factory Programmed 128-bit Serial Number

Atmel Corporation 

5. Pin Description

Serial Clock (SCL): The SCL input is used to positive edge clock data into each EEPROM device and negative edge

clock data out of each device.

Serial Data (SDA): The SDA pin is bidirectional for serial data transfer. This pin is open-drain driven and may be

wire-ORed with any number of other open-drain or open-collector devices.

Device/Page Addresses (A2, A1, A0): The A2, A1 and A0 pins are device address inputs that are hard wired for the

AT24CS01/02. As many as eight 1-Kbit or 2-Kbit devices may be addressed on a single bus system. For more detail, see

section, “Device Addressing” on page 10.

Write Protect (WP): AT24CS01/02 has a Write Protect (WP) pin that provides hardware data protection. When the Write

Protect pin is connected to ground (GND), normal read/write operations to the full array are possible. When the Write

Protect pin is connected to VCC, all write operations to the memory are inhibited but read operations are still possible.

This operation is summarized in Table 5-1 below.

Table 5-1. Write Protect

WP Pin

Status

At VCC

At GND

Part of the Array Protected

Atmel AT24CS01/02

Full Array

Normal Read/Write Operations

Atmel AT24CS01/02 [PRELIMINARY DATASHEET]

4

8815A–SEEPR–6/12

Share Link: