ICs for Audio Common Use
AN7194K, AN7194Z
s Electrical Characteristics at VCC = 12 V, f = 1 kHz, Ta = 25°C
Parameter
Symbol
Conditions
Min Typ Max Unit
Quiescent current
Standby current
Output noise voltage *1
Voltage gain
Total harmonics distortion
Maximum output power 1
Maximum output power 2 *2
Ripple rejection ratio *1
Channel balance *1
Cross-talk *1
Output offset voltage
Muting effect *1
Standby terminal voltage
ICQ VIN = 0 mV, RL = 6 Ω
150
ISTB VIN = 0 mV, RL = 6 Ω
1
VNO RG = 10 kΩ, RL = 6 Ω
0.22
GV VIN = 24.5 mV, RL = 6 Ω
38 40
THD VIN = 24.5 mV, RL = 6 Ω
0.2
PO1 THD = 10%, RL = 6 Ω
8 10
PO2 THD = 10%, RL = 6 Ω
30 44
RR RL = 6 Ω, RG = 10 kΩ
VR = 1 V[rms], fR = 1 kHz
45 60
CB VIN = 24.5 mV, RL = 6 Ω
−1 0
CT VIN = 24.5 mV, RL = 6 Ω, RG = 10 kΩ 50 60
VOFF RG = 10 kΩ, RL = 6 Ω
−300 0
MT VIN = 24.5 mV, RL = 6 Ω
60 82
ICQ-STB VIN = open, VSTB = 5 V
250 mA
10 µA
0.5 mV[rms]
42 dB
0.6 %
W
W
dB
1 dB
dB
300 mV
dB
50 µA
Note) *1 : Measurement using a bandwidth 15 Hz to 30 kHz (12 dB/OCT) filter.
*2 : VCC = 24 V
s Usage Notes
1. Always attach an outside heat sink when using the chip. In addition, the outside heat sink must be fastened onto
a chassis for use.
2. Connect the cooling fin to GND potential.
3. Avoid short circuit to VCC and short circuit to GND, and load short-circuit.
4. The temperature protection circuit will be actuated at Tj = approx. 150°C.
However, it is automatically reset when the chip temperature drops below the above set level.
5. The overvoltage protection circuit starts its operation at VCC = approx. 26 V.
6. For the standby voltage, a stabilized power supply of 3 V or higher should be used.
7. Only when being used in combination with the AN7077Z, this IC can operate up to the supply voltage of approx.
25.4 V which is the maximum output voltage of the AN7077Z.
3