EM78P156EL Просмотр технического описания (PDF) - Elan Microelectronics Corp

Номер в каталоге

Компоненты Описание

производитель

EM78P156EL

8-BIT MICRO-CONTROLLER

Elan Microelectronics Corp 

EM78P156EL

OTP ROM

• Bits 0~3,5 Not used.

9. IOCF (Interrupt Mask Register)

7

6

5

4

3

2

1

0

-

-

-

-

-

EXIE

ICIE

TCIE

• Bit 0 (TCIE) TCIF interrupt enable bit.

0: disable TCIF interrupt

1: enable TCIF interrupt

• Bit 1 (ICIE) ICIF interrupt enable bit.

0: disable ICIF interrupt

1: enable ICIF interrupt

• Bit 2 (EXIE) EXIF interrupt enable bit.

0: disable EXIF interrupt

1: enable EXIF interrupt

• Bits 3~7 Not used.

• Individual interrupt is enabled by setting its associated control bit in the IOCF to "1".

• Global interrupt is enabled by the ENI instruction and is disabled by the DISI instruction. Refer to Fig.

10.

• IOCF register is both readable and writable.

4.3 TCC/WDT & Prescaler

An 8-bit counter available as prescaler for the TCC or WDT. The prescaler is available for either the

TCC or WDT only at any given time, and the PAB bit of the CONT register is used to determine the

prescaler assignment. The PSR0~PSR2 bits determine the ratio. The prescaler is cleared each time the

instruction is written to TCC under TCC mode. The WDT and prescaler, when assigned to WDT mode,

are cleared by the “WDTC” or “SLEP” instructions. Fig. 5 depicts the circuit diagram of TCC/WDT.

• R1 (TCC) is an 8-bit timer/counter. The clock source of TCC can be internal or external clock input

(edge selectable from TCC pin). If TCC signal source is from internal clock, TCC will increase by 1 at

every instruction cycle (without prescaler). Referring to Fig. 5, CLK=Fosc/2 or CLK=Fosc/4 application

is determined by the CODE Option bit CLK status. CLK=Fosc/2 is used if CLK bit is "0", and

CLK=Fosc/4 is used if CLK bit is "1". If TCC signal source comes from external clock input, TCC is

increased by 1 at every falling edge or rising edge of TCC pin.

• The watchdog timer is a free running on-chip RC oscillator. The WDT will keep on running even when

the oscillator driver has been turned off (i.e. in sleep mode). During normal operation or sleep mode, a

WDT time-out (if enabled) will cause the device to reset. The WDT can be enabled or disabled any

This specification is subject to change without prior notice.

15

07.29.2004 (V1.3)

Share Link: