2
Mechanical and Electrical Specifications
2.1 Mechanical Characteristics
Table 2. Mechanical Characteristics @ VDD = 2.5V, VDDIO = 1.8V, T = 25°C unless otherwise noted.
Parameter
Test Conditions
Symbol Min Typ Max
Unit
FS[1:0] set to 00
±2
2g Mode
Measurement Range(1)
FS[1:0] set to 01
FS
±4
g
4g Mode
FS[1:0] set to 10
±8
8g Mode
FS[1:0] set to 00
2g Mode
4096
Sensitivity
FS[1:0] set to 01
So
4g Mode
2048
counts/g
FS[1:0] set to 10
8g Mode
1024
Sensitivity Accuracy(2)
Soa
±2.64
%
FS[1:0] set to 00
2g Mode
Sensitivity Change vs. Temperature
FS[1:0] set to 01
4g Mode
TCSo
±0.008
%/°C
FS[1:0] set to 10
8g Mode
Zero-g Level Offset Accuracy(3)
FS[1:0] 2g, 4g, 8g
TyOff
±17
mg
Zero-g Level Offset Accuracy Post Board Mount(4)
FS[1:0] 2g, 4g, 8g
TyOffPBM
±20
mg
Zero-g Level Change vs. Temperature
-40°C to 85°C
TCOff
±0.15
mg/°C
Self-Test Output Change(5)
X
Y
Z
FS[1:0] set to 0
Vst
4g Mode
+181
LSB
+255
+1680
ODR Accuracy
2 MHz Clock
%
±2
Output Data Bandwidth
BW
ODR/3
ODR/2 Hz
Output Noise
Normal Mode ODR = 400 Hz Noise
126
µg/√Hz
Output Noise Low Noise Mode(1)
Normal Mode ODR = 400 Hz Noise
99
µg/√Hz
Operating Temperature Range
Top
-40
+85
°C
1. Dynamic Range is limited to 4g when the Low Noise bit in Register 0x2A, bit 2 is set.
2. Sensitivity remains in spec as stated, but changing Oversampling mode to Low Power causes 3% sensitivity shift. This behavior is also seen
when changing from 800 Hz to any other data rate in the Normal, Low Noise + Low Power or High Resolution mode.
3. Before board mount.
4. Post Board Mount Offset Specifications are based on an 8 Layer PCB, relative to 25°C.
5. Self-Test is one direction only.
MMA8451Q
6
Sensors
Freescale Semiconductor, Inc.