CS5531-AS Просмотр технического описания (PDF) - Cirrus Logic

Номер в каталоге

Компоненты Описание

производитель

CS5531-AS

16-bit and 24-bit ADCs withUltra-low-noise PGIA

Cirrus Logic 

CS5531/32/33/34-AS

caused an operational issue for customers

because their start-up sequence includes

writing a word (with RS=0) into the

configuration register after performing a

reset. The change in the reset sequence to

include writing the RS bit back to 0 insures

the clearing of the RS bit in the event that a

user does not write into the configuration

register after the RS bit has been set.

The RV bit in the Configuration Register is set to

indicate a valid reset has occurred. The RS bit

should be written back to logic “0” to complete the

reset cycle. After a system initialization or reset,

the on-chip controller is initialized into command

mode where it waits for a valid command (the first

8-bits written into the serial port are shifted into the

command register). Once a valid command is re-

ceived and decoded, the byte instructs the converter

to either acquire data from or transfer data to an in-

ternal register(s), or perform a conversion or a cal-

ibration. The Command Register Descriptions

section can be used to decode all valid commands.

16

DS289F5

Share Link: