MAX3664 Просмотр технического описания (PDF) - Maxim Integrated

Номер в каталоге

Компоненты Описание

производитель

MAX3664

622Mbps, Ultra-Low-Power, 3.3V Transimpedance Preamplifier for SDH/SONET

Maxim Integrated 

622Mbps, Ultra-Low-Power, 3.3V

Transimpedance Preamplifier for SDH/SONET

INREF1 and INREF2

Connect INREF1 and INREF2 as close to the AC

ground of the photodetector diode as possible. The

photodetector AC ground is usually the ground of the

filter capacitor from the photodetector anode. The total

loop (from INREF1/INREF2, through the bypass capaci-

tor and the diode, and back to IN) should be no more

than 2 cm. long.

Wire Bonding

For high current density and reliable operation, the

MAX3664 uses gold metallization. Make connections to

the die with gold wire only, and use ball bonding tech-

niques (wedge bonding is not recommended). Die-pad

size is 4 mils square, with a 6 mil pitch. Die thickness is

12 mils.

VCC and Ground

Use good high-frequency design and layout tech-

niques. The use of a multilayer circuit board with sepa-

rate ground and VCC planes is recommended. Take

care to bypass VCC and to connect the GND pin to the

ground plane with the shortest possible traces.

VCC

FILTER

CAP

OUT+

PIN DIODE

OUT-

IN

OUT+ OUT-

COMP

Figure 4. Suggested Layout for TO-46 Header

_______________________________________________________________________________________ 9

Share Link: