DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

25Q16BV Просмотр технического описания (PDF) - Winbond

Номер в каталоге
Компоненты Описание
производитель
25Q16BV Datasheet PDF : 68 Pages
First Prev 11 12 13 14 15 16 17 18 19 20 Next Last
W25Q16BV
11.1.6 Status Register Protect (SRP1, SRP0)
The Status Register Protect bits (SRP1 and SRP0) are non-volatile read/write bits in the status register
(S8 and S7). The SRP bits control the method of write protection: software protection, hardware
protection, power supply lock-down or one time programmable (OTP) protection.
SRP1 SRP0 /WP
Status
Register
Description
0
0
X
Software /WP pin has no control. The Status register can be written to
Protection after a Write Enable instruction, WEL=1. [Factory Default]
0
1
0
Hardware
Protected
When /WP pin is low the Status Register locked and can not
be written to.
0
1
1
Hardware When /WP pin is high the Status register is unlocked and can
Unprotected be written to after a Write Enable instruction, WEL=1.
1
0
X
Power Supply Status Register is protected and can not be written to again
Lock-Down(1) until the next power-down, power-up cycle.(2)
1
1
X
One Time Status Register is permanently protected and can not be
Program(1) written to.
Note:
1. These features are available upon special order. Please refer to Ordering Information.
2. When SRP1, SRP0 = (1, 0), a power-down, power-up cycle will change SRP1, SRP0 to (0, 0) state.
11.1.7 Erase Suspend Status (SUS)
The Suspend Status bit is a read only bit in the status register (S15) that is set to 1 after executing an
Erase Suspend (75h) instruction. The SUS status bit is cleared to 0 by Erase Resume (7Ah) instruction
as well as a power-down, power-up cycle.
11.1.8 Quad Enable (QE)
The Quad Enable (QE) bit is a non-volatile read/write bit in the status register (S9) that allows Quad SPI
operation. When the QE bit is set to a 0 state (factory default), the /WP pin and /HOLD are enabled.
When the QE bit is set to a 1, the Quad IO2 and IO3 pins are enabled, and /WP and /HOLD functions are
disabled.
WARNING: If the /WP or /HOLD pins are tied directly to the power supply or ground during
standard SPI or Dual SPI operation, the QE bit should never be set to a 1.
- 14 -

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]