12C509 Просмотр технического описания (PDF) - Microchip Technology

Номер в каталоге

Компоненты Описание

производитель

12C509

8-Pin, 8-Bit CMOS Microcontrollers

Microchip Technology 

5.0 I/O PORT

As with any other register, the I/O register can be

written and read under program control. However, read

instructions (e.g., MOVF GPIO,W) always read the I/O

pins independent of the pin’s input/output modes. On

RESET, all I/O ports are defined as input (inputs are at

hi-impedance) since the I/O control registers are all

set. See Section 7.0 for SCL and SDA description for

PIC12CE5XX.

5.1 GPIO

GPIO is an 8-bit I/O register. Only the low order 6 bits

are used (GP5:GP0). Bits 7 and 6 are unimplemented

and read as '0's. Please note that GP3 is an input only

pin. The configuration word can set several I/O’s to

alternate functions. When acting as alternate functions

the pins will read as ‘0’ during port read. Pins GP0,

GP1, and GP3 can be configured with weak pull-ups

and also with wake-up on change. The wake-up on

change and weak pull-up functions are not pin

selectable. If pin 4 is configured as MCLR, weak pull-

up is always on and wake-up on change for this pin is

not enabled.

5.2 TRIS Register

The output driver control register is loaded with the

contents of the W register by executing the TRIS f

instruction. A '1' from a TRIS register bit puts the

corresponding output driver in a hi-impedance mode.

A '0' puts the contents of the output data latch on the

selected pins, enabling the output buffer. The

exceptions are GP3 which is input only and GP2 which

may be controlled by the option register, see Figure 4-

5.

Note:

A read of the ports reads the pins, not the

output data latches. That is, if an output

driver on a pin is enabled and driven high,

but the external system is holding it low, a

read of the port will indicate that the pin is

low.

The TRIS registers are “write-only” and are set (output

drivers disabled) upon RESET.

PIC12C5XX

5.3 I/O Interfacing

The equivalent circuit for an I/O port pin is shown in

Figure 5-1. All port pins, except GP3 which is input

only, may be used for both input and output operations.

For input operations these ports are non-latching. Any

input must be present until read by an input instruction

(e.g., MOVF GPIO,W). The outputs are latched and

remain unchanged until the output latch is rewritten. To

use a port pin as output, the corresponding direction

control bit in TRIS must be cleared (= 0). For use as an

input, the corresponding TRIS bit must be set. Any I/O

pin (except GP3) can be programmed individually as

input or output.

FIGURE 5-1: EQUIVALENT CIRCUIT

FOR A SINGLE I/O PIN

Data

Bus

D

Q

Data

WR

Latch

VDD

Port

CK Q

P

W

Reg

TRIS ‘f’

D

Q

TRIS

Latch

CK Q

N

I/O

pin(1,3)

VSS

Reset

(2)

RD Port

Note 1: I/O pins have protection diodes to VDD

and VSS.

Note 2: See Table 3-1 for buffer type.

Note 3: See Section 7.0 for SCL and SDA

description for PIC12CE5XX

© 1999 Microchip Technology Inc.

DS40139E-page 21

Share Link: