KIA78L05F Просмотр технического описания (PDF) - KEC

Номер в каталоге

Компоненты Описание

производитель

KIA78L05F

BIPOLAR LINEAR INTEGRATED CIRCUIT

KEC 

KIA78L05F~KIA78L24F

PRECAUTIONS FOR USE

When such a high voltage as exceeds 10V beyond the fixed output voltage(Typ. value) of is applied to its output terminal,

IC may be destroyed. In this case, connect a zener diode between the output terminal and GND to prevent application of excessive voltage.

In particular, in such a current boosting circuit as shown in application circuit example(2), if input voltage is suddenly applied by stages

and furthermore load is light, excessive voltage may be applied transiently to the output terminal of IC. In such a case as this, it may

become necessary to increase capacity of output capacitor as appropriate, use a smaller R1(a resistor for bypassing IC bias current)

or gradually rise input voltage in addition to use of a zener diode as mentioned above.

SOLDERING

Flat Package (SOT-89 Package)

Elements mounting styles of electronic devices are gaining in further diversification over recent years, and needs for components

are all the more expanding in varieties. Especially, surface mounting is steadily penetrating into industrial segments as a world-wide

popular technical trend. Although exposure to high temperature is inevitable during soldering we recommend limiting the soldering

temperature to low levels as shown in figure for the sake of retaining inherent excellent reliability.

240

210

150

60 sec.

Time (sec.)

Within 10 sec.

Within 30 sec.

Fig 6

(a) When employing solder reflow method

① Atmospheric temperature around resin surfaces must be less than 240℃, not exceeding the time length of 10 sec.

② Recommend temperature profile

③ Precautions on heating method

When resin in kept exposed to high temperature for a long time, device reliability may be marred.

Therefore, it is essential to complete soldering in the shortest time possible to prevent temperature of resin from rising.

(b) When employing halogen lamps or infrared-ray heaters

When halogen lamps or infrared-ray heaters are used, avoid direct irradiation onto resin surfaces; such devices cause

extensive localized temperature rise.

※ Please keep a reflow solder operating when SOT-89 package’s soldering.

2014. 2. 26

Revision No : 6

15/16

Share Link: